Meraki MX64 VPN Client

[mrSajid]

Hi,

I have CISCO Meraki MX64 and "Client VPN" (under Security and SD-WAN) is configured properly. Hence I can connect and authenticated to it using VPN client from Windows 10. Everything works perfectly fine for a about half a minute but after that all traffic stops and I can't even ping or browse anything. What could be the reason for this issue? 

Kindly suggest a solution. 

Thanks a lot, 

Sajid 

[PaulMcG]

If the same subnet is configured on your home router and on the MX LAN, this could cause an issue like this.  Most home routers have something like 192.168.0.0/24 or 192.168.1.0/24, and if this is the same as a vlan on the MX, the computer doesn't know which way to route.

[PhilipDAth]

Commonly this is a firmware issue on CPE routers.  Are you connecting from home?  Is the router that you use to connect to the Internet have the latest firmware?

[Pdriver]

Hello

Does this happen no matter where you connect from -Have you tried a different client?

Does the logging report anything -client/mx?