Meraki

AlanSmithe · ‎Nov 12 2019

So Meraki doesn't support extended vlan's?

NolanHerring · ‎Nov 2 2018

How do you have the MX64 connected? Is your WARM-SPARE status showing Active/Ready? As @PhilipDAth mentioned, if your doing warm-spare, you have to use the virtual IP configuration mode so that the client can use the vIP for it to function.

Zilla · ‎Oct 24 2018

Check to make sure you are not running BPDU guard on the links between your switches.

ciph3r · ‎Oct 23 2018

There appears to be alot missing from this diagram. Where are these MX devices located? A datacenter? In pass through mode you can not port channel the devices directly.

Luffy · ‎Oct 17 2018

Thank you 🙂

AjitKumar · ‎Oct 16 2018

Hi I understand "Yes". Kindly check the following Url for more Information. https://documentation.meraki.com/MX/Networks_and_Routing/Passthrough_Mode_on_the_MX_Security_Appliance_and_Z1_Teleworker_Gateway

AjitKumar · ‎Oct 16 2018

Hi, Port Channel on MX WAN Interfaces? I believe shall not be possible. Port Aggregation feature is available on switches. WAN interfaces can offer us Load balancing and Load sharing features. Check the following Url for more information https://documentation.meraki.com/zGeneral_Administration/Tools_and_Troubleshooting/Link_Aggregation_and_Load_Balancing#Link_Bonding_(a.k.a._teaming.2C_bundling.2C_etc.)

Tony_Ang · ‎Jun 11 2018

The only way to do is to setup per floor as per network. It's not a good practice but that's the only way. As per network you can do 15 SSID so it should be fine. But you can make a wish in the wish tab 🙂 Regards Tony

Luffy · ‎May 30 2018

I understand what you said. Thank you for your answer 🙂

Luffy · ‎May 29 2018

Thank you for your great answer. I understand what you said. But I can't control ISP modem. ISP modem give me public IP directly, not NAT. I think to use Warm spare, It needs one more public IP in my case. Thank you 🙂

Meraki

Community

About Luffy

Luffy

Community Record

Badges

Re: MX LAN Trunk Port with Non Meraki Switch

Re: Client VPN issue on the warm spare mode

Re: MS Warm Spare issue

Re: HA connection diagram

Re: Dual WAN and Same vIP subnet

Re: IPS function in Pass through mode

Re: Meraki MX WAN port channel

Re: Maximum SSID count

Re: Port channel using MS warm spare

Re: Question about MX Warm Spare setting

Re: Question about MX Warm Spare setting