Any port going up and down will trigger an STP event, not an election that could be disruptive, but a notification. ... View more

It’d also helpful to track down the devices involved in the conflict, identifying the MAC addresses can give you a clearer idea of what’s going on. As for the DNS setting, switching from "proxy to upstream DNS" probably won’t fix the conflict unless there’s a specific DNS-related issue. It doesn’t hurt to test, but I’d focus more on the DHCP setup and device configurations. ... View more

Hi @kYutobi ,        Thank you for the verification. I'll try to get documents and datasheet for the configuration. ... View more

Hi @CarolineS ,     Yes, I going to update these concerns once I got more information. ... View more

Hi @PhilipDAth ,          If I separate each port of the switch in 3 VLANs, what are the configurations that I need perform. The MPLS was Layer 2 MPLS. How can we configure the MX on VLAN considering that HA setup is the same configuration? ... View more

Check your event logs for any DAI (Dynamic Arp Inspection) errors. You may have to enable/disable "Trusted DAI" on your individual ports or turn it off altogether based on your needs. You can disable this feature under Switching -> Monitor -> "DHCP Servers and ARP". ... View more

Hi @ammahend,        Like for example I connect to the Wi-Fi and when I check the properties of my laptop Wi-Fi adaptor it shows the password. ... View more

Hi @cmr ,         Ah I see, anyway thank you for the information regarding upgrade. Then for your question why our client do that, because they have own standard with regards upgrading firmware, they always want behind -2 on the latest firmware. ... View more

Yes, it needs internet to work. ... View more

Switches do not have mac ports, they have a single mac which is the system mac. ... View more

So where did I configure the setting of the 1 hour limit per day? is it in the Meraki dashboard splash page frequency or in the radius server or captive portal itself?   ... View more

Thank you for the link I'll try to check this one ... View more

Hi @alemabrahao thank you for your response.  ... View more

@CarolineS this is in the wrong category.    Edit - has been moved now.  ... View more

Sir thank you because I confirmed the overlapping on IP subnet that I put on private subnet on configuration on Meraki MX site to site, because when I saved the configuration with different subnet the saving is successful but on sonic wall side they're using only one IP subnet which is 192.168.0.0/24. Is there any other config on Meraki Site to site VPN that I need to configure? Right now both MX are in Hub config. Or I have to configure on sonic wall side? Thank you in advance ... View more