@MarcAECthanks for your reply. Yes as per auto vpn it will failover but worry is how remote site subnet access internet ? As Soon as DIA link goes down entire traffic will be failover to MPLS link and it will go to HUB.., do I require me to add any routing on HUB or Remote sides to make sure seamless for internet access, especially VOIP as they are using internet link for SIP tunnel  ... View more

@MarcAEC  Hi, I am looking for same kind of solution where i have 2 WAN links at my Remote sites.., where WAN1 is for Internet access(through Zscaler tunnel) locally and WAN2 is MPLS where site Private subnet (Intranet traffic - example: 10.14.x.0/24 - which includes VOIP subnet)  will reach DC for Servers hosted. Now i wanted a seemless failover(for Internet traffic) to WAN2 if site WAN1(Internet Link) goes down., how can i achieve will you be able to help ?? ... View more

Hi @PhilipDAth  as per your suggistion i had added flow preference below is the error we are getting..,   There were errors in saving this configuration: The IP address range 10.20.33.234/32 does not apply to any configured subnets. The IP address range 10.20.33.235/32 does not apply to any configured subnets.   ... View more

Hi Phillip,   Thanks for your reply, I understood that we can not add static route via WAN port. But WAN2 port is still DOWN that will come up only if that interface reachable to Internet for that reason we want to add static rotue towards the LAN which firewall has Internet connection.  Do you think if i add Flow Preference source as "MPLS Private subnet" and desitnation as "Dashboard IP's " and Preferred Link as "WAN1" which is Internet connected at the moment.   Please we need your advise on this problem.., we have deployment on Friday.  ... View more

Hi All,   i am facing same kind of issues.., can some help on this ??    my WAN1 is conencting to Internet and WAN2 is to MPLS.   I need to maintain a Auto VPN for both WAN's..    At the moment my WAN2 interface status showing as "Failed" and not able to ping the gateway(which is ISP router and directly connected)   I know WAN2 interface will be active once it has internet reachability., but for i am trying to add one static route pointing to my Firewall interface from same subnet.., but again below error i am getting.   "The static LAN route "test" has an invalid next hop IP. The IP address 10.20.33.236 is not on a configured subnet"   kindly suggest on anove problem as we deployment in a week.   ... View more

you are right @DarrenOC  it is disabled and i can see credentials as well., do I  have use the same credentials to access the local page or need to remove the device from the network ? ... View more

Thanks Bruce for youe help 🙂 I had created two networks for MX450 and 250 each. ... View more