Good news , I received today the replacement . :-)))   Hope that they are not defective, I will install when I can. We close the premises due to COVID-19.   I had to fight hard and after 30 emails to the support they finally push the right button.     ... View more

@MerakiDave a little help would be appreciated on this one .   thank you  ... View more

Bumping an old thread, I am surprised to see this information is still not exposed in the dashboard.  Had a power event at one of our sites and was trying to verify if the Meraki equipment power cycled.  Not exposed in the dashboard, had to call support for them to verify device uptime.  Can anyone from the Meraki side request getting this added.  Plenty of wishes made for an otherwise easy feature to deploy. ... View more

I see it as more of an issue with distance from a switch. Wireless can extend your reach to an area that is over 100m and has power readily available (not different than an AP in mesh mode).   ... View more

I was on the phone recently with Meraki support with an unrelated issue, and I just deployed my first set of MS120s. The tech on the phone mentioned to run 10.25 (beta) on the MS120s. They ship with an earlier 10 code deployed on them. So far they have been running okay. ... View more

Of course! I'm hoping it just becomes the next stable RC version and isn't only in the beta tree. ... View more

Hi Justin,   it does, Actually I had also a similar issue last week with two MR52...intermitent cuts , not at the same time but identical behaviour. After checking the cable, Poe and factory reset I went for a RMA. Since your case seems to be  model based and much more critical given the amount of AP affected I would quickly contact Support and ask for a RMA after confirming  that cable and PoE (Have you tried to plug any of those faulty AP to another port/switch with external power adaptor ? ) are ok and  factory reset  is not solving the problem. To me it seems something out of your control since it is quite random , very likely  related with any meraki backend issue. Hope it helps.   ... View more

9.32 is now released as new "stable" firmware (no longer in beta).   I have only had one one bug with 9.32.  When using the policy of blocking DHCP servers by default (so that you have to white list allowed DHCP servers), and you have a VLAN that the Meraki switches have no layer 3 interface in, and you have another non Meraki device acting as a DHCP relay for that VLAN into another VLAN that does have a L3 Meraki interface in - you can not whitelist the non-Meraki DHCP relay MAC address (when you click save it fails to save just that one MAC address), and the switches incorrectly block DHCP in that VLAN.   A pretty rare case, so I doubt that others will run into it. ... View more