it has been working ok, for the last 6 months, but now it keeps on restarting, I have tried a factory reset but the issue still persists.
what could be the problem?
thanks
Hi @pope , I would reach out to Meraki support and raise a support ticket. This way if you need to replace the device they can RMA it.
Could be any number of issues, cpu utilisation causing it to fail and reboot, hardware issues, code/firmware issue etc etc
This happened to me too, After an RMA it would still occur. It turned out that we had too many clients as per the recommended usage which caused high cpu usage and in turn a reboot. We had to upgrade to higher models in the end.
You can see the utilization on the firewall by going to Organization > Monitor > Summary Report and picking the network that the firewall is located in. Scroll to the bottom of the report and you can see the firewall utilization over time and see if it is to high for too long. The latest beta firmware for the MX75 implements multi-threading and could possibly help with throughput some, but maybe at the cost of overall stability from running beta firmware.
As @DarrenOC has already suggested, reaching out to Meraki Support (via a dashboard case or the Meraki support line) would be the best course of action here. The reboots can be associated with the hardware itself, physical issues (such as power), or even firmware. Logs on the device itself can also provide information on potential causes. Meraki support will look into all of these potential causes and may ask you to provide those logs.
@pope what do you see in the event log for the reboot, this is now recorded since recent changes and you should see similar to the below where the power lead was pulled as part of some ISP troubleshooting: