configuration IP static switches

[nst1]

because I have several switches connected to the same switch and configured with static IP but some of them I already see them in the dashboard and some do not show me the message

 "This device is using a DHCP IP address from VLAN instead of using configured VLAN 1."

but all computers have the same network segment configured

What I can do ?????

[BrandonS]

Did you type VLAN 1 when you entered static IP?  You want to leave that blank if you intend to have management on your native VLAN.

[nst1]

my switches have this configuration, but with different IP

[PhilipDAth]

This happens when the switch can not talk to the Meraki cloud using the configured parameters. Make sure their is not an upstream firewall blocking traffic.

[Adam]

Also if you have rebooted the switches a few times, sometimes it just takes a bit to stabilize.  I've had to leave mine overnight with no changes on more than one occasion for them to finally take the static IP settings. 

[ww]

did you set :

Configure > Switch settings and specify the desired VLAN in the "Management VLAN" section.