MS 9 vs. 10

RVilhelmsen
Getting noticed

MS 9 vs. 10

What is the difference between firmware 9.x and 10.x?

3 Replies 3
ww
Kind of a big deal
Kind of a big deal

at firmware upgrades you can check release notes

 

Additions

  • Enhanced Storm Control (not available on MS22/42/120/220/320)
  • Dynamic ARP Inspection (not available on MS22/42/120/220/320)
  • SM Sentry Wired Security Integration on MS
  • IPv6 ACLs (not available on MS22/42/220/320)
  • STP Anomaly detection
  • STP Loop Guard
  • Equal Cost MultiPath (ECMP) routing (not available on MS42/320/210/225)
  • Increase minimum fan speed on MS225-48LP/FP series switches to address a condition that can result in fan failure
  • Reduced bootup times for MS120 series switches
  • Unidirectional Link Detection (UDLD)
  • Support for Multi-Host and Multi-Auth access policy modes
  • Ability to download diagnostic data about the device from the local status page
RVilhelmsen
Getting noticed

well, i was more thinking if there is any difference on the OS version and no so much features.

Like, is ver. 9 linux 3 and ver. 10 is linux 4 ... or is it only new features which makes the difference.

 

PhilipDAth
Kind of a big deal
Kind of a big deal

We don't know about the OS.  There are a lot of stability improvements in the 10.x code as well.  If you can. use the 10.x code.  It is much better.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels