We've connected a Cradlepoint E3000 Router to our Cisco Meraki switch and set the static route to go to the Cradlepoint's IP address which is on our network, however, we don't seem to be getting speeds from the Cradlepoint. The Cradlepoint speed test would show anywhere above 100Mbps, but yet the computers get 1Mbps.
HI @Shadius , could you supply further details around your network setup? What switches do you have downstream from the router? Do you have L3 VLAN interfaces on those switches. How's the router connected into the LAN? Are you routing on a stick?
Darren O'Connor | uccert.co.uk https://www.linkedin.com/in/darrenoconnor/
I'm not an employee of Cisco/Meraki. My posts are based on Meraki best practice and what has worked for me in the field.
The trace route shows it timing out on the 4th hop.
After inputting a static route on the WAN router for it to go to the Cradlepoint E3000 Router (172.16.150.9), the trace route shows it starts at the interface IP (172.16.150.11), then goes to the Cradlepoint E3000 Router's IP, but times out from the 4th hop to the 8th hop, then resumes on the 9th hop.
When removing the static route of 172.16.150.9, there is no timeout, but computers get 1Mbps speeds, which is our WAN circuit speeds.
Also, a speed test ran from the Cradlepoint's NetCloud Manager resulted in over 100Mbps speeds.