Hi, all,   We've configured all of our ports of our core switch (MS425-32) to be mirrored to a destination port on the same switch. The destination port has a device connected to it that is being used to capture the traffic from the source ports.   The issue that we're having is that the traffic shows the IP address of the wireless access point instead of the IP address of the client that is connected to the wireless access point.   How would I be able to achieve this? ... View more

Hi Meraki Community,   The issue I need help to resolve is getting phone paging to work across multiple floors that each have their own networks for their phones.   I have three floors with their own networks.   I want to be able to send a page from a phone that's on the second floor to phones on the third & fourth floor and vice versa. Right now, I can only do it on the same floor from the same floor. Example: Paging from a phone on the second floor only works on the second floor. The third and fourth floor does not get the page.   We have Yealink SIP-T54W phones. Voice VLANs for each floor for the phones. Multicast routing is enabled with an address of 224.0.1.75 as provided by our vendor.   Any help is appreciated!     ... View more

Hi all,   I recently received a Cisco 891F-K9 router and an MS130-8X switch. I'd like to set them up to use for a home lab to start learning.    I have Verizon as my ISP.    How would I set these up?    I'm assuming the Cisco 891F-K9 router will plug into one of the LAN ports on the Verizon router for Internet access.    Any help is appreciated!  ... View more

I've got a weird issue where I can no longer assign a static IP address to the MR57 wireless access points we have deployed and the wireless access point remains offline. The switchport is a trunk port using the management VLAN of the switch.   Screenshots below:   Switchport configuration:   I've input the static IP address into the wireless access point's configuration, but it will not come online. I've tried cycling the switchport, but still nothing. I've tried changing the switchport to an access port and using another VLAN, but still nothing. I read in another post that you're supposed to leave the VLAN in the access point's configuration blank, but even that didn't work.   What am I doing wrong?   ... View more

Hey all,   I am trying to set up a site-to-site VPN between two sites, our data center and one of our offices. The data center is using a Cisco ASA and the office is using an MX250. The office also has a Cisco 2811 router that we use for our WAN connectivity.   The VPN has been configured on the Cisco ASA and in Meraki, but we're not able to access our shared drives, and can't ping from the data center to the office.   How can I set up this site-to-site VPN between the data center and the office so that our network resources are accessible? ... View more

Hi all,   I would like to know how to remove Cisco Umbrella from a Meraki network.   I want to be sure that anything that was previously linked or had anything to do with Cisco Umbrella is totally gone from the network/organization.   How can I achieve this?     ... View more