Meraki

wsalomon75 · ‎Jan 16 2024

Thanks for the response! VLANs are enabled on this Z3. Since you're a Meraki employee, if you could look at my dashboard, it's the EMS_2_Shellpoint Z3.

wsalomon75 · ‎Jan 16 2024

Hello all, I'm trying to turn on some ports on a Z3 that I have connected, but is part of a template. Normally, I would do this through "Addressing/VLANs" and edit the ports, but that's nowhere to be found on this Z3. I'm assuming it has something to do with it being part of a template. Any ideas? Thank you!

wsalomon75 · ‎Nov 28 2023

I JUST saw this! Thank you!

wsalomon75 · ‎Nov 28 2023

Hello all, I'm upgrading a site's Meraki MX68W to a MX75 because they upgraded their speeds to 500/500, and I want to know if it's possible to easily copy the settings from the site over to the new MX75. Is this possible? I'm new to using Meraki, so any help and explanations would be greatly appreciated. Thank you, William

wsalomon75 · ‎Oct 20 2023

In short, we have a print server located on our network for VLAN 710. We have a number of satellite offices that use the Meraki network, and I need to put a networked printer on a few of them. Without creating VLAN 710 w/ that printer subnet, how can this be accomplished? Just create a dummy subnet on each with the 710 VLAN and tag those ports?

wsalomon75 · ‎Oct 19 2023

Hello all, I'm trying to tag a VLAN on a device plugged into port 3 on the device. I don't want to add the VLAN in the VLAN and Addressing menu, because this VLAN/Subnet will be used among multiple Meraki devices in the future, and it's my understanding that once you add the subnet, that subnet cannot be used in another Meraki device. So I guess my question is, can I easily tag traffic for that VLAN without adding the subnet to the local device?

wsalomon75 · ‎Jan 31 2023

This is exactly what it was. Being new to the org and setting up Merakis, I didn't know they had this configured. Thank you for the help!

wsalomon75 · ‎Jan 30 2023

Hello all, I have 8 connected MR46s to a Cisco 9300 on a new floor, with a new config, and after installation, I added the MR46s to our current network of wireless devices. They are showing as connected, took our configs, and when I go to tools and ping out to say, www.google.com they get a response. However, when I go to the floor and stand directly underneath an AP, I'm getting no signal at all, despite showing a green light on the device and the SSID being broadcast. I have checked the power, and it's the same config as the 3rd floor which is working just fine. Any ideas on what to check?

Meraki

Community

About wsalomon75

wsalomon75

Community Record

Badges

Re: Turning off/on ports on a Z3 with a template configuration

Turning off/on ports on a Z3 with a template configuration

Re: Copying Config from MX68W to MX75

Copying Config from MX68W to MX75

Re: Meraki Z3C-NA: VLAN tagging on a access port

Meraki Z3C-NA: VLAN tagging on a access port

Re: 8 Meraki MR46 new installs, connected, no transmit power

8 Meraki MR46 new installs, connected, no transmit power

Re: Copying Config from MX68W to MX75