I don't know the answer - but I suspect you'll get an alert whenever it sees a DHCP server not currently displayed in the list (and those are time based).     ... View more

Thank you very much. Reading over this today. ... View more

I ended up calling Meraki support, and if use you use a template for a network that has has an aggregate port, it won't pull the tag. you'd have to remove it from the template. otherwise, it works fine for any uplinks that aren't in a port group.  ... View more

Thanks for the tip. I have also noticed that if the status is 'Forwarding' some have BPUDguard enabled and some do not. It does not distinguish, but only states 'Forwarding'.  ... View more

Any explanation why its normal? Its kinda flooding the logs if it happens multiple times a second. ... View more

The solution for this problem with the MAC-addresses was so set this commands on the Cisco Catalyst ports (with IP-phones with inbuilt switch and other unmanaged switches connected to Cisco Catalyst switches):   switchport port-security aging time 2 switchport port-security aging type inactivity   So, the switch forgets the MAC addresses on this port after 2 minutes. Then you can plug the devices to another place and it works. Since then I didn´t had this problem, and I don´t know if Meraki MS switches handels this otherwise, because for them I don´t have an "forget MAC addresses" command. ... View more

Thank you.  ... View more