About npnitin

npnitin · ‎06-18-2022

Dear Experts, We have deployed two MS425 switches as CORE and MS125 as Access switches. In the client section, we have seen each client seems two times means the same client shows on the Access and Core switch. So, please assist me to understand why this happens.

npnitin · ‎05-05-2022

we are using MR 76 AP in our environment. We are facing the below issue: IoT devices connected to AP for less than 1 min then move to another AP and stay there for 1 min after that disconnect and then connect to the other AP. AP to AP distance in 12-17 meter. Please assist me in this regard

npnitin · ‎04-22-2022

Earlier we have use a analog sensors for measuring temperature and humidity in Foundry. Which some time showing wrong result due to that processing material would be futile. Then we have shifted to Cisco Industrial Asset Vision Sensors like AV201 and Cisco IXM gateway. Now we got a real time data of temperature and humidity through the dashboard which resulted in increasing productivity.

npnitin · ‎12-09-2021

Yes, you are correct. AP connected to MS120 switch. Now I am Off shift but I will be able to access the device tomorrow at 11.00 AM(IST). But why does this issue occur?

npnitin · ‎12-09-2021

How do I send you a serial number? If I share SN here then everyone can see

npnitin · ‎12-09-2021

Hello Expert, In my new deployment, I register my switches(MS) successfully and then connect AP to the switch. AP getting an IP address from the DHCP server which I see on the switch ARP table. and I ping AP from my all switches but when I ping from AP where ping failed. Also AP not register on Meraki Portal Please assist me in this challenge

npnitin · ‎12-02-2021

Thanks for your reply. I want to give some details of my ongoing deployment. We use one subnet for all wired and wireless networks so all users including IoT are in one subnet. All IoT devices use only a wireless network and other users connected on the wire. So please advise, how can I implement these policies?

npnitin · ‎12-01-2021

Hi Experts, I want to use MAC filtering to access the wireless network. But I don't have a RADIUS server. Most of the devices are IoT based So, please guide me on this matter. In this case, I will be installing MR76

npnitin

Community Record

Badges

Client shows on Access switch as well as on Core

MR76 - Connected and disconnect

Re: Happy Earth Day!

Re: Able to ping MR76 but not able to register on Meraki dashboard

Re: Able to ping MR76 but not able to register on Meraki dashboard

Able to ping MR76 but not able to register on Meraki dashboard

Re: Wi-Fi Access using MAC filtering

Wi-Fi Access using MAC filtering

Re: Happy Earth Day!