Thank you!! ... View more

@Richard_W wrote: I found a gnome is that an egg? Gnomes are not eggs 🙂 ... View more

We swapped out our MX84's for MX100's and it happened with 2 MX100's in an HA configuration.  Meraki does not recommend a direct connection for heartbeats between the 2 MX devices any longer.  We now have 2 MX100 devices with the HA one powered off.  This is ridiculous. ... View more

@Jacobs_02it is supported but android version but i think lenovo just like being difficult on some things. we also have samsung tab A's that worked amazingly and also did the same thing to my galaxy work phone and was great. feel like i was doing systems manager wrong the whole time ... View more

Glad you got it taken care of ... View more

This visitor - they are using a client VPN? If so, the client VPN should be giving out the custom DNS servers. ... View more

So i had this same issue where i blocked p2p on my wifi and it still went through, i have a Fortinet firewall and had to block it there via an application policy to kill all Torrent software ... View more

i just got these tablets as well and ran into the same issue and followed those direction and here is what happened to me   C:\Users\******\Downloads\platform-tools_r28.0.1-windows\platform-tools>adb shell dpm set-device-owner com.meraki.sm/ .DeviceAdmin usage: dpm [subcommand] [options] usage: dpm set-active-admin [ --user <USER_ID> | current ] <COMPONENT> usage: dpm set-device-owner [ --user <USER_ID> | current *EXPERIMENTAL* ] [ --name <NAME> ] <COMPONENT> usage: dpm set-profile-owner [ --user <USER_ID> | current ] [ --name <NAME> ] <COMPONENT> usage: dpm remove-active-admin [ --user <USER_ID> | current ] [ --name <NAME> ] <COMPONENT> dpm set-active-admin: Sets the given component as active admin for an existing user. dpm set-device-owner: Sets the given component as active admin, and its package as device owner. dpm set-profile-owner: Sets the given component as active admin and profile owner for an existing user. dpm remove-active-admin: Disables an active admin, the admin must have declared android:testOnly in the application in its manifest. This will also remove device and profile owners Error: Invalid component com.meraki.sm/ C:\Users\*******\Downloads\platform-tools_r28.0.1-windows\platform-tools>adb shell dpm set-device-owner com.meraki.sm/ .DeviceAdmin     I sent in a Help Case to see what the correct thing to do here is ... View more

Like others said check to make sure trunks are working. Are you receiving DHCP addresses? Can you reach gateway of each subnet? Can you ping across subnets? Are you plugging into an access port properly configured for needed VLAN or are you connecting to a Trunk and getting dumped into the native VLAN? ... View more

Good afternoon, thank you for your help. folks ... View more

Thanks for your reply, and everyone else's replies, very helpful!   Thanks,   Andy ... View more

i would say run the wire for the ground. better to be safe with that measure. Shielded ethernet couldn't hurt but then it raises your cost of the project a bit. ... View more