My MS120-48LP already become dormant, even i have RMA the switch also showing offline on Meraki Dashboard. But in local the internet all is working. I hope there is solution to get back the switch online at Meraki Dashboard. ... View more

Can you share the tunnel VPN configuration on AWS side? Thank you ... View more

it's a inhouse time series database, built for fast ingestion and long term storage and the front end is a inhouse flexible dashboarding framework.  ... View more

Looking at pcaps I see when it pings a RFC1918 IP the source is the highest VLAN IP with VPN enabled. When pinging a "public" IP the source is the WAN IP.  ... View more

UPDATE - We finally got a resolution to the problem. Seems all trains of version 17 of the MX firmware had issues. Since moving to 18.x we seen a massive drop in MX device utilization. ... View more

Hi Raphael, We've got a few large customers with MX450s that have been maxing out their 'device utilization' and when we contacted TAC they were able to provide detailed CPU reports for the MX Hubs showing the CPU is hitting over 100% regularly. This is causing latency issues, HA failover and some OSPF drops to its neighbouring core switch. We have optimised the MX's as much as we can and it did improve. But CPU has slowly crept up again. They are suggesting we fail over the to the standby MX as the first test. We'll do that tonight. The other customer we have they've offered an extra MX to load balance the traffic. Smells to me like there are known issues.  Would be good to get an API call for it but I'm guessing they don't want us to know. Let me know how you are going with a resolution. We'll being going vMXs in a few months so that might be our 'fix' Cheers Barry  ... View more

Any fix for this problem. Or we waiting for another firmware update? ... View more

I have the same question. We're looking at enabling IDS/IPS on our AutoVPN spoke MX's, but that has the adverse effect of bricking the vulnerability scans against clients/devices behind the spokes. The only exceptions I thought I saw were for particular rules, rather than particular IP's. ... View more

Cheers for the reply   I'm stuck with a vendor using TFTP right now as their device is only coded for TFTP (Quite old device) I'm going run a local TFTP server to get around this problem as it's only a one off problem for now. ... View more

My ports are back, thanks for your response. ... View more

Liquid damage would be classed as accidental damage so no covered.   As suggested you could reach out to your Meraki account manager, maybe they can pull some strings and get someone on board to help out.    Hope you guys are keeping safe across the ditch! ... View more

Ok, so I think it only works in templates when the VLAN IP schema is using "same". If using "unique" then it's not shown. And it's not something available as a local override outside of the template for a template bound network. ... View more

This is something we can help with, although right now we use SNMP if you want uplink traffic stats as the API call is per device which doesn't scale terribly well.   https://apps.meraki.io/details/service-assurance-for-sd-wan ... View more

I have had support come back to me saying there is a known issue with claiming orders at the moment. ... View more

100 % not going down that route again 🙂 ... View more

Usage is a rolling average of the load on the CPU core(s) that our packet forwarding engine runs on. 100% on its own isn't necessarily an issue, unless you're noticing concerning amounts of packet queuing or loss. ... View more

ps. If you used the aio library to loop through the orgs and networks it would be a lot faster. ... View more