About Network-dad

Network-dad · ‎09-21-2020

Welcome to the community @cyriel95

Network-dad · ‎09-15-2020

Are they running the same addressing? I have seen issues with the VPN and remote network conflicting IP addresses.....

Network-dad · ‎09-15-2020

Welcome @ChanelCollege to the community, if you have any questions please feel free to ask. everyone on here is so helpful and supportive.

Network-dad · ‎07-27-2020

Hello Everyone, So we currently have our Guest network setup in NAT mode: Use Meraki DHCP.. We are looking to improve the guest experience and don't want them disconnecting and re-authenticating as the walk around our locations.. With that said I was planning on using Layer 3 roaming with a concentrator but I want client isolations... any tips on setting this up? Is VPN: tunnel data to a concentrator better and how do I ensure client isolation.

Network-dad · ‎07-27-2020

Welcome to the community @Webster !!! if you have any questions please feel free to reach out and ask...

Network-dad · ‎07-23-2020

These would be a nice pair to go with my pluralsight socks.

Network-dad · ‎07-10-2020

Thank you everyone who has helped me along my journey to get to this point!!!! This community is amazing and is full of amazing people!!! Keep up the hard work everyone!

Network-dad · ‎07-09-2020

@SarthakRane You can look at the Historical Data on the Appliance Status page for the last month and see all the reboots.

Network-dad · ‎07-09-2020

Welcome to the community!!!

Network-dad · ‎07-07-2020

Make sure to set your antenna type in the dashboard ... the auto detect doesn't always work. Here is some info on the MA-ANT-20 dual-band omni antennas. https://meraki.cisco.com/wp-content/uploads/2020/05/meraki_datasheet_antenna_omni_4_7dBi.pdf

Network-dad · ‎07-07-2020

We have deployed several MR74's with dual-band omni antennas and they work great.... I would be slightly worried about people trying to connect 110ft away in a parking lot full of cars....the MR74 should do fine as long as you have line of sight... if there is any trees in the parking lot that will decrease the rang of the AP.

Network-dad · ‎07-07-2020

Do you have a Meraki Rep yet? We just did a lunch and learn with our and got a personalized one on one deep dive into Meraki SD-WAN.. (I knew a lot but it helped bring my co workers up so speed).. its a good way to learn and ask all your questions.. if you don't have a rep you can check out this webinar if you haven't yet. https://meraki.cisco.com/webinars/introduction-to-sd-wan-with-meraki-mx/

Network-dad · ‎07-07-2020

Welcome Stephan to the community!! glad to have you here!

Network-dad · ‎07-06-2020

Here is a little Monday pick me up everyone!!! Let me know which one was your favorite or add your own. 1. Sums it up 2. Well it works some times. 3. We have all been there. 4. Ah, yes, a signature joke. 5. Packet CHOMP 6.This is my life now

Network-dad · ‎07-06-2020

Do you still have the iPhone it may have not been compleatly removed for the org. https://documentation.meraki.com/SM/Device_Enrollment/Uninstalling_Systems_Manager_and_Removing_Managed_Devices Hence why it is still using a license...

Network-dad · ‎07-06-2020

Any enrolled devices will show up under the devices tap under MDM... where are you seeing this? is it under licenses?

Network-dad · ‎07-06-2020

Welcome Manuel to the community!! The CMNA is great but if you want to learn more the what makes Meraki work ide take the ECMS1 & 2 classes... Tons of valuable information. https://community.meraki.com/t5/Learning-Hub/ct-p/hub

Network-dad · ‎07-06-2020

Welcome to the community @JosephHays ! Thank you for you service as well!!

Network-dad · ‎07-02-2020

right now not too much but I was practically living on it... I was flying 3 day a week

Network-dad · ‎07-02-2020

@SoCalRacer wrote: @Network-dad wrote: For just an small non Meraki in room AP I travel with one of these https://amzn.to/3glwRuC For a Meraki solution I travel with a Z3 https://meraki.cisco.com/product/security-sd-wan/teleworker/z3/ Pretty much my exact recommendation, also my preferred device is Z3C for travel since I use the T-Mobile SIM in it all the time. Screw Marriott Wifi! I usually bring a chromecast device and then I can stream pretty much anything I want and not be on the hotel wifi and I get wired access if needed. Only downside is TSA looks at you kind of funny. (#Small Flex) Flying corporate don't have to deal with TSA... 😁

Network-dad · ‎07-02-2020

Welcome Daniel to the community!!! Glad to have you here.

Network-dad · ‎07-02-2020

Welcome to the community Antonio!

Network-dad · ‎07-02-2020

For just an small non Meraki in room AP I travel with one of these https://amzn.to/3glwRuC For a Meraki solution I travel with a Z3 https://meraki.cisco.com/product/security-sd-wan/teleworker/z3/

Network-dad · ‎07-01-2020

Devices only become active once they connect to the Meraki cloud over the internet... Also they will go into a dormant state if thy haven't connected in more than a week. https://documentation.meraki.com/zGeneral_Administration/Cross-Platform_Content/Status_Icon_Meanings

Network-dad · ‎07-01-2020

I've have taken over our Meraki deployment with our company and with that I have upped my A game in the community... I love helping people and just glad to be here!

Network-dad

Dakota Seufert-Snow

Community Record

Badges