Worth a read: https://documentation.meraki.com/Architectures_and_Best_Practices/Cisco_Meraki_Best_Practice_Design/Meraki_Cloud_Architecture
... View more
Hi @FlyingFrames - the dashboard will always be available. In all the years I’ve been working with Meraki devices the dashboard has always been available
... View more
There we go 😁 The AM either doesn’t understand that the license in your dashboard can be applied to any MT or they’re trying to upsell. Just buy your MT device from an online retailer or find a smaller Partner that you can work with.
... View more
Hi @Boyan1 , my understanding is that the free MT licences can be used against any Meraki IOT device such as the MT10. What happens when you assign the MT10 to your network? Is it Meraki telling you otherwise or is there a Cisco Partner involved here?
... View more
Hi @NEWLinc , that feature needs to be enabled by support as per the below document https://documentation.meraki.com/MX/Site-to-site_VPN/Using_Site-to-site_VPN_Translation
... View more
Hi @AVL , firstly, are you able to power cycle the AP in anyway (shut, no shut the switch interface)? What firewall do you have upstream in the network? Are you seeing any traffic being blocked that would affect device registration to the Meraki Cloud?
... View more
I wonder if this is related at all….. https://community.meraki.com/t5/Switching/Introducing-SFP-Optic-Health-Monitoring-with-Digital-Optical/m-p/247237
... View more
Hi @B_97 , quick thought and might be a tad cumbersome but could you create a new Org every month and use the devices for that period, run down the trial license and then start the process over again.
... View more
Hey @JAEspinosa1 , it really did have me chasing my tail for a period! I could see traffic traversing the customers firewall, the devices were in the right VLAN and were getting the correct management IP but for a second it me doubting myself.
... View more
Good Afternoon all, During a recent install i had a bit of a nightmare installing a batch of MR44's that were new but had been in storage for a little while (approx 9-12 months). The AP's were in the Org's inventory so was just a case of moving them into the customer's existing assigned Network (which i must stress already had a number of MR44's correctly registered). The AP's would get an IP address but would just stay showing as "Never connected to the dashboard". Many hours later the AP's started to register. I checked the event log from which we could see a large qty of errors stating - Device reboot - reason: firmware upgrade failed. This happened on both 30.6 and then 30.7. Anyone seen this behaviour before?
... View more
Should be a straight forward process to migrate from one batch of external IPs to your new allocation. Note your existing settings on your MX, NAT rules etc then amend to the new.
... View more
hi @JAEspinosa1 , tongue in cheek here but I would do the following: - shutdown the link to the Ubiquity - Power down the Ubiquity Switch - Unrack the Ubiquity. - replace switch with anything other than Ubiquity
... View more
Full requirements doc can be found here: https://documentation.meraki.com/Cloud_Monitoring_for_Catalyst/Onboarding/Cloud_Monitoring_for_Catalyst_Onboarding_Guide#Eligible_Catalyst_Devices
... View more
