Hi,    Recently migrated to meraki equipment, with switches and access point What I have noticed is that sometimes with different computers the pages do not load me completely.   I have to update them and it takes a while and shows me completely this happens with LAN and Wifi, en ese momento dejo un ping -t y el ping nunca se pierde   My speed is not because at that moment I do a speed test and the speed in good I thought that the pages I was trying to open had problems but I open them from my cell phone using my network and without problems open them.   I'm currently using Google DNS.   What may be happening or what configuration I'm missing or should I check ?????? ... View more

  how can I lower the power or signal strength to an MR42, what happens is that I have two MR42 very close and I want to avoid that both teams collide ... View more

    I have a network meraki with several switches today I saw that two swtches lost connectivity as if they had been disconnected from the electrical power or disconnected the network cable.   What can I check ???   Also in one of the teams says there was a change in the topology that is due ?? ... View more

      How can I download the configuration of my switch ports ??? I mean I want to see what port is connected to which switch, laptop, Access Poitn etc. ... View more

  I have a new Wi-Fi Meraki installation, but on my computers windows 10, 8, 7 shows me a yellow symbol and tells me that I do not have internet. But if I open an explorer I sail without problem. What is happening or what should I do to avoid the alert. ??? ... View more

    Can I use a fiber and ethernet SFP from another brand in my Meraki switches? ... View more

    I have two different sites; the first has 2 MX two Core switches, access switches, access point and their own VLANs   the second has 1 MX 1 switch core, access switches, access point and its own VLANs   The first site has its own Internet access with its corresponding public IP   My Access points are trunk in the ports of the corresponding switches and the rest of the ports are access   So   The second site does not have its own Internet access and does not have a public IP Then the second site will go online through the first site. I have thought that I only have to configure the VLANs of the second site in the MX and in the Primary Core. Is my idea correct or should I consider what I should do ???? ... View more

  I have this static route and this transit VLAN   I want to delete tje transit VLAN and it does not allow it.       neither does it allow me to edit it   neither does it allow me to delete it, route static       ... View more

    because I have several switches connected to the same switch and configured with static IP but some of them I already see them in the dashboard and some do not show me the message    "This device is using a DHCP IP address from VLAN instead of using configured VLAN 1."   but all computers have the same network segment configured   What I can do ????? ... View more

    com I can configure a range of ports with more than two VLAN access mode, in meraki switch ???? ... View more

    I have 10 vlan in my meraki dashboard, in the core switches.   in the access switches I tag in the ports but some vlan do not give ip (but all have their scope configured) and some other vlan do not give me internet (for example I use the same vlan in different switches and in some I have Internet exit and others do not) What I can do ?? ... View more

  I have two switches model MS425-32 already place the cable stack (crossed between the switches)   I see the ports green, but the board shows me the alert "This switch is not connected to a stack." What should I do ??? or what do I still have to do ??? ... View more

  I can connect the stack cables in any port of the switch or do I have to use some in specific ??? ... View more