Client made a request to the DHCP server, but it did not respond
I've researched this issue and so far haven't found a similar case, so I've signed up to ask for some advice
I have an MR36 running 27.7.1 connected to an MS250-48LP running in test as a PoC for a network wide roll out
I have a Guest SSID distibuting it's own DHCP, and a Production SSID configured to use the local LAN DHCP server.
In the production SSID, I'm getting the DHCP error in the subject, however, clients are getting a valid IP address from the server, with the correct gateway etc, and a lease visible in the DHCP lease list on the Windows server. However the client claims there is no internet access
The MS250 is currently configured to block rogue DHCP servers but specifically allow the DHCP server in question, it's worth noting that client devices connected to the switch via copper are getting addresses and connecting out without issue, there is no L3 configured on this network
Any suggestions of where to look would be a great help, thanks in advance
Hi Guys, I've managed to put some time aside for this, and to answer some of the questions above, there is no Layer 3 happening on this network currently everything is on default VLAN 1, the Local LAN rule is set to allow, the client gets a valid address but can't ping the gateway, let alone the internet, and there are numerous other AP's with the same config on the same firmware functioning in other businesses under the same corporate ownership. The following packet capture shows the DHCP exchange from the server at x.x.x.2: