Meraki MS-125 Unable to access Local Status Page

SOLVED
Mike05
Here to help

Meraki MS-125 Unable to access Local Status Page

Hi Masters,

 

Just want to ask if somebody encountered the issue I am facing with MS125-48 switch.

Currently, I can't access the local status page so that I can setup proxy settings.

 

I've tried below.

* Laptop set to obtain DHCP.

1. Connect LAN cable to dedicated management at the back of the unit.

2. Check IP address - none (APIPA).

3. Tried to access switch.meraki.com ; my.meraki.com ; setup.meraki.com - all failed.

 

*Laptop set to 1.1.1.99/24

1. Connect LAN cable to dedicated management at the back of the unit.

2. Tried to access 1.1.1.100 - failed

3. Ping 1.1.1.100 - failed.

 

Together with this unit are stacked MS350-24X, the local status page pops up automatically upon connecting to management port so it's just the 3 x MS125-48 that I'm having trouble.

 

Any ideas?

 

TIA,

Mike

1 ACCEPTED SOLUTION
ww
Kind of a big deal
Kind of a big deal
8 REPLIES 8
ww
Kind of a big deal
Kind of a big deal

Did you try on a switch lan port, combined with static ip address on the client 

KarstenI
Kind of a big deal

There were a couple of Release/model combinations where the Management-port didn't work for the local status page. Have you also tried a LAN-port for this?

Mike05
Here to help

Hi @ww , @KarstenI ,

 

Thank you for your response.

 

Initially, I added and managed it in the Dashboard so I'm able to change the IP address from there.

Its just that during the deployment, I was informed that customer by default has no internet unless you use proxy.

 

I set the IP Address in 172.26.x.x subnet, in this case, should I connect to normal LAN port then access http://172.26.x.x?

 

Regards,

Mike

ww
Kind of a big deal
Kind of a big deal
Mike05
Here to help

Hi @ww ,

 

Understood, so meaning I still need to access it based in the original management IP.

I'll give it a try when I go onsite tomorrow and give you a feedback.

 

Thanks,

Mike

BlakeRichardson
Kind of a big deal

@Mike05  Is local management page access enabled in your dashboard as its something that can be disabled.

 

Network-wide > Configure > General 

 

Screen Shot 2021-12-06 at 9.32.55 AM.png

Meraki CMNO, Ruckus WISE, Sonicwall CSSA, Allied Telesis CASE & CAI

Hi @BlakeRichardson ,

 

Thank you for your response.

I will explore this option, I'm still new in using Meraki Dashboard 🙂

 

Regards,

Mike

Mike05
Here to help

Hi @ww , @KarstenI ,

 

It works!

So that's the way in case I can't access using dedicated management port.

 

Anyway, thanks to all of your replies.

 

Regards,

Mike

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels