Faster than the bot ...!
Right screen, right time 😂
SmartPorts Automation with Trunk ports as the Smart port profile still does not work.
The SmartPorts Automation selects the right SmartPort profile but the trunk config of the SmartPort profile does not work.
When applied manually (the same SmartPort profile) everything works.
I gave up on the support case, but I cannot be the only one in the world with this problem.
Just wiped the config and tried all over.
Still the same.
The Automation selects the right port-profile, but the trunk port-profile only allows traffic on its native vlan, all other vlans are blocked somehow.
And again, the fun thing is that the mac-address table of the switch actually tells you that there is a client in the (in this case) tagged vlan 10 on that port, but no traffic.
A packet capture on that Automated port, actually captures incomming packets tagged with the VLAN , but there is never any reply from the network.
*sigh*
PS: This was done on a MS130-12X, perhaps it works on other platforms ?
>using "admin" as the username,
All Meraki devices should strive to be the same. I don't think it is good when just one family member does something different to all the other family members.