MV2 still unreachable after the power comes up

Andre_Afonso
Here to help

MV2 still unreachable after the power comes up

Hi Guys,

 

I have on site with one MX67W one MR33 and one MV2.

In the MR33 I had created 2 SSID to connect the MV2 Wireless profiles (Principal and Backup).

The costumer is facing some power issues that makes the whole network get´s down. When they the devices come back online, the MV2 get´s unreachable to the dashboard but is connect to the power, I guess is because we can´t establish a connection to MR33.

 

Is anyway to fix this issue?

 

Regards,

 

AA

Andre Afonso
6 REPLIES 6
cmr
Kind of a big deal
Kind of a big deal

Put a UPS on the MX67 to power it and the MR33 (assuming it is PoE from the MX), you won't need a large expensive one.

Hi, a UPS was suggested to customer. But that doesn't fix the problem when MV2 try to connect to SSID after the power gets down.

Andre Afonso
ww
Kind of a big deal
Kind of a big deal

Try power it off. Bring it near the mr.  And power on.

 

Check the ap network if the mv try to connect to the ssid.

The MR is verry close from the MV.

Andre Afonso
BlakeRichardson
Kind of a big deal

I would plug the MV directly into a POE switch if you can and confirm that the unit is good. Continual power issues could have cause an issue with it. 

Meraki CMNO, Ruckus WISE, Sonicwall CSSA, Allied Telesis CASE & CAI

For that you you need the additional hardware MA-PWR-ETH.

The problem here is, after the power come on, the camera get´s confusion and don´t know how to connect to SSID.

Andre Afonso
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.