Thanks. In fact, load factors in previous period had disappeared... ... View more

Hello,   My customer asked the following:   Do the Cloud Archive Licenses cover all cameras for the single quantity listed, or would that be the price per camera? If it does cover multiple cameras, is there a maximum limit to cameras that it would cover? If it is priced per camera, can the amount of storage be divided across multiple cameras? As in, instead of 90 days of cloud storage for 1 camera, can it be split to 15 days of cloud storage for 4 cameras? --I have replied: It is the price per camera. It can be moved from one to another camera, but not multiple cameras at the same time. I assume (I am asking for clarification) that splitting the 90 days as described above is not supported/possible (math aside).   Am I correct? Is there other information I should included?   Thank you! ... View more

@Nick wrote: If you can I would always go with an MR33, obviously its environment specific but its a much more capable device Agreed. ... View more

They are not updated in any particular order.   When the update is scheduled all affected switches start the firmware download.  They then wait for up to 20 minutes for other switches to finish their download, and then reboot and do the upgrade. https://documentation.meraki.com/Architectures_and_Best_Practices/Cisco_Meraki_Best_Practice_Design/Best_Practices_for_Meraki_Firmware#Best_Practice_for_MS_Firmware   You can use the staged switch upgrade tool to do switches in a particular order. https://documentation.meraki.com/MS/Other_Topics/Staged_Upgrades_for_Meraki_Switches   Note if you upgrade any switch in a physical stack all switches will upgrade and reboot. ... View more

@PhilipDAth is correct and I have tried it, works great.  With MS11 firmware you can run dual power supplies on your MS350 in combined mode to double the PoE budget.  You can go to Switch > Configure > Switch Settings and set a default for all capable switches in the network to default to redundant power or combined power.  And then you can set custom lists of switches that will always use redundant power and/or always use combined power to override any defaults.   ... View more

The best work around for this (until Meraki enables dual LTE capability which I keep dreaming about) would be to purchase a separate LTE modem like pepwave offers https://www.peplink.com/products/max-cellular-router/multi-cellular/ and use it to plug into the WAN port on your MX. ... View more

Hi Jesse, Thank you for your prompt support! ... View more

Hi, Adam   Thank you for your reply.   I'm sure that construction as simple edge router is difficult...and looking forward MX can use BGP in overlay/underlay. ... View more

Unfortunately there are no deployment guides for the vMX yet other than the deployment instructions here: https://documentation.meraki.com/MX-Z/Installation_Guides/vMX100_Setup_Guide_for_Microsoft_Azure & https://documentation.meraki.com/MX-Z/Installation_Guides/vMX100_Setup_Guide_for_Amazon_AWS   As @kevinl mentioned, you can deploy multiple vMX appliances to scale the VPN connections.  ... View more

I don't, but I suppose it might be possible to discover by forcing an update and capturing with Wireshark. Do you also have MX?   It would simplify packet capture.   I suppose you have capped/expensive internet service?   ... View more

Hi  Similar devices in a single network update at the same time.   Also I believe the firmware size is in MBs.  However I shall reiterate the upgrade download is negligible. I have not experienced heavy downloads atleast for MRs.   ... View more

Thanks for quick reply! ... View more