@TomasB, If you found this post helpful, please give it kudos. If my answer solved your problem, click "accept as solution" so that others can benefit from it. ... View more

I think its posted in the public release notes of MG 3.102    MG’s have yellow status on Organization > Overview when on Cellular ... View more

We have the same issue, all sites with a MG is Yellow but the MG it self is green and up and running.   Have you still the same issue 4 years later? 🙂 ... View more

If you have just a single MX, you have no onsite servers and all your SVIs (default gateways) are handled by the MX, then I'd say you were fine to link all your switches direct to the MX, reducing hop count etc - in such a setup, there would be no loops to resolve and no advantage from ASIC-powered routing (in a L3 switch).   If you are using warm spare (dual MXs) I'd definitely go with @KarstenI 's recommendation;   aggregate your switches to a stack of two switches, then put resilient links in as per the Recommended Topologies section of the warm spare document that @alemabrahao linked - and use Spanning Tree to resolve loops as needed and 're-open' blocked links when required upon failure. ... View more

2.5 hours is a long time, the longest I've had was 20 mins. Firmware usually needs to be updated but that still shouldn't take that long.   It may pay to check with support as they may be able to give an insight to what happened.   ... View more

At this point we are running the latest stable fw 28.7.1. We also have AX disabled across the environment along with 802.11k disabled. ... View more

Zebra MC9300 on Android 8.1 (Security Patch Level January 2021) or Android 10.0 (patch revision 70 - Security Patch Level April 2021)      ... View more

Here we go again.....#   https://community.meraki.com/t5/Wireless-LAN/AP-showing-as-offline-on-Portal/m-p/146214   https://community.meraki.com/t5/Wireless-LAN/AP-s-dropping-of-network/m-p/146244#M20410     And Here the "Resolved" tread: https://community.meraki.com/t5/Meraki-Service-Notices/Dashboard-connectivity-in-Europe-region/ba-p/143816     this is not acceptable.   Last week, there were again these incorrect displays for various customers. Your developers should not smoke so much pot     ... View more

We are running 28.5    @TomasB Its a mix, one site hosts the primary DHPC so another remote location will access DHCP over the MPLS and we are seeing the errors from both locations.  We are considering moving DHCP to the local Meraki switches - has anyone done this? ... View more

Indoor, on the 2.4Ghz we're much lower, works fine (4 - 10), but on 5Ghz near the same 👍 ... View more

Those event log messages are just showing that client balancing is taking place. It doesn't necessarily mean anything is wrong. I rarely see client balancing cause any negative effects. However, any easy test is simply disable it under teh RF profile and see if your issue goes away. ... View more