Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About phelimmc
Community Record
30
Posts
2
Kudos
0
Solutions
Badges
Hi, Can anyone please advise. Two SSID's use the same VLAN on our network, devices have no issues when connected to one SSID and can break out to the internet. When devices are connected to the other SSID on the same AP they connect okay but it stated "no internet". This occurs on different models of APs. It doesn't make sense as there doesn't seem to be an issue at the service provider end as one SSID works using the same VLAN as the other. Thank you
... View more
Labels:
- Labels:
-
SSID
Hi, Can anyone please advise? when using NAT mode with Meraki DHCP can traffic still be tagged to use different VLANs. When testing we have noticed when the client IP assignment is set to Meraki DHCP traffic defaults to the native VLAN. We would prefer it to default to other VLANs instead of the the native VLAN when using this method is this possible? Thank you
... View more
Labels:
- Labels:
-
SSID
Can anyone advise please the MS120-8FP switch we use is networked and live. Is it possible that we can connect a MS220-8P switch to it by network cable to establish network connectivity on it also. We have set both ports on both switches to the same native VLAN, allowed VLANs set to all and disabled POE on both ports that we will connect the network cable on both switches. We plan to connect the network switches then by network cable so the MS220-8P is networked? is this possible between these two switch models or will it only work on a like for like model? Thanks
... View more
Fantastic well done! you have sorted it 🙂 just assigning the static IPs to the relevant APs. Much appreciated. For my knowledge why can't you tag the AP mgmt IP and have it native/untagged on the switch?
... View more
Yes it's the same VLAN we are using DHCP from, all the switches revert to static IP without issue but for some reason the AP's don't or don't reflect the change to static addressing on the relevant AP page.
... View more
Hi, Can anyone advise please why the IP address of an AP is not changing to static when instructed within their web portal but shows within the switch page as the correct static IP address. For example within Wireless->Access Points->AP1 displays as LAN IP (DHCP) even though it has been changed to a static IP address. When you select Switch->Switches below Clients AP1 displays as the static IP address you have assigned it. What can be causing this mismatch of the switch recognising the correct AP address but the AP not within it's page?
... View more
© 2025 Cisco Systems, Inc.
