Hi Team,  We have a requirement that i cannot seem to find a solution to. We have site to site VPN's configured (1 hun and 3 spokes) We have a server running some VM servers at the HUB site and have some webapps on a server with ip ending in .23 . We need to have the internal computers resolve a URL xxx.xxx.xx.cloud:8061 to the internal ip ending in .23.  Currently, the external ISP DNS resolves the URL to our WAN IP address and we have a port forward in place to get to the server but our webapps support are claiming it is not right.     Is there any internal process that can resolve the url to our internal IP.  The webapps do not need to be accessed externally either.  Regards ... View more

Hi all,  I have a client running 2 x WAN an Optus FTTN connection and then a Starlink as WAN2,  The client VPN is working with Optus but the connection is experiencing a lot of packet loss issues and we want to use Starlink (wan2) as the primary connection. I made the changes but then we lost access to the client VPN. I have the Starlink router in "Bypass" mode which I'm assuming is bridge mode. I get a WAN IP on the appliance status page and all looks good.  I have tried to configure the client VPN as the hostname and the Starlink IP    Has anyone actually had it working in the field?? Regards Anthony ... View more

Hi All, i am having an issue with a client. When their primary connection fails, the 3cx handsets then register with the fail over 4G connection which then turns them to junk (as typical 3/4G connections do)  Is there a way i can create a rule that they phones (mac address or ip address) can never use WAN2?? Regards Anthony ... View more

Hi All,  This is a bit odd and we have been going in circles.    We are an Apple service center. When we run Apple service diags through the MX it blocks it. We have tried to open the firewall but have spent a lot of time and still cannot get to work.  We have a permanent server on-prem and then the client machines come and go (customers machines)    Can we allocate a port (lan4) on the MX68 to be fully open? and then we run the server and client through port 4 to avoid data being blocked? Regards Anthony ... View more

Hi I have an MX68 and it is running fine on the primary link with VPN but when the primary link fails the VPN will not connect through the 4G fail over (telstra). The 4G modem (teltonika RUT240) connected to WAN2 has all its defaults set with no open ports.  Can the telstra connection be blocking it? Thanks in advance  Anthony ... View more

Hi everyone,  We are an Apple auth store and have an Apple server that runs diagnostics on client devices. before we installed our MX68 it would work perfect, but now the unit under test connects and then times out. Apple claims that our server needs full internet on port 80 or 443 to work. no forwarding is required.  Does anyone know how I can create a rule to suit? ... View more

Hi All,  I am having an internet connection issue between an MX68 and Draytek Vigor 2762n.  I have set the connection to always on and entered the Draytek into Full "Bridge" mode. The Cisco connection is set to "No VLAN tag" Direct and I have entered the static IP.  Every two hours the connection is dropping out and about half an hour later it comes back.  What should I do to start diagnosing the drop?  In the past, I have used the Draytek Vigor 130 and not had issues but the customer already had the Draytek 2762.  Thanks for any input. Regards Anthony ... View more