Community Record
15
Posts
7
Kudos
1
Solution
Badges
May 12 2022
8:35 AM
5 Kudos
Updating post here as we now support up to 32 sensors per MV and MR if you are latest GA versions of code for MV/MR.
... View more
Oct 27 2020
6:54 AM
1 Kudo
Yes - changes made in a Template are automatically pushed to all Networks bound to that Template. Bear this in mind, when organizing your Dashboard; where might you need to test a planned change, in a limited way, before you push that change to all sites...? There are, however, a number of settings that cannot be locally overridden. It should become obvious to you what these are, by loooking at 'Configure' on a Network bound to a Template. https://documentation.meraki.com/General_Administration/Templates_and_Config_Sync/Managing_Multiple_Networks_with_Configuration_Templates#Local_Overrides What do you need to change, per Network? Remember there are essentially no limits to the number of Templates you can use. If something needs to be locally over-ridden for a subset of sites - maybe you need more than one Template? If Templates are ultimately not flexible enough for you, that's where the Dashboard API comes in, for automating changes at scale.
... View more
Oct 6 2020
6:58 AM
1 Kudo
As @KarstenI said, I would use both NICs for hypervisor and guests. Tag all the guest VLANs and the hypervisor connection, then on the switch ports set as trunk with no native VLAN. Alternatively an easier setup to get up and running, though a little less secure, is to leave the hypervisor untagged and set it as the native VLAN on the switch trunk ports.
... View more
Sep 3 2020
9:44 AM
Thanks everyone :). I'll do a network and just move the AP i want to upgrade
... View more
Aug 19 2020
5:02 PM
2 Kudos
Hi @nikmagashi Indeed you figured it out: Shared secret field: it the shared secret to be configured on Windows VPN Client as well Secret field in Radius section: it the PSK/Secret to configure with Radius client on NPS server Regarding the IP Address to associate with the Radius Client on NPS Side, this meraki KB is really helpful and explains the different cases https://documentation.meraki.com/MX/Client_VPN/Configuring_RADIUS_Authentication_with_Client_VPN#Add_MX_Security_Appliance_as_RADIUS_clients_on_the_NPS_server On an intranet, If your MX uses a static route to reach out the NPS Server, you will have to use MX IP of network segment used by this route. If your MX relies on VPN tunnel to reach out NPS, use the MX IP of the highest-numbered VLAN Interface set "in VPN" I hope it helps
... View more
Aug 19 2020
3:02 AM
Thanks for the quick response, I tried the Security & SD WAN Tab yesterday, with no results. But today I went to Layer 7 Firewall Rule and deleted all the rules - and it helped. Thank you very much!
... View more
Kudos given to
My Accepted Solutions
Subject | Views | Posted |
---|---|---|
2525 | Aug 18 2020 8:02 AM |
My Top Kudoed Posts
Subject | Kudos | Views |
---|---|---|
1 | 2955 | |
1 | 2525 |