Meraki

Community

About jel

Re: Resolve "Alerting" status

by in Meraki Go
‎Nov 17 2019 8:57 PM
‎Nov 17 2019 8:57 PM
Oddly enough, since I posted this message the other two devices have come online and appear to be OK. I won’t be at the office to check first hand until tomorrow AM.  As for IPs, I’m referring to wired and wireless clients on the network. It seems the APs were issued 192.168.x.x addresses and all the other clients have 10.x.x.x ones. I’ve always seen every device on a LAN have the same first two, but perhaps that’s not an indication of anything being right or not.  ... View more

Re: Resolve "Alerting" status

by in Meraki Go
‎Nov 17 2019 8:22 PM
‎Nov 17 2019 8:22 PM
Cable Internet to Modem Modem to Security Gateway Security Gateway to a port on the switch Each AP wired directly to the switch and using PoE   And another clue:  All the clients are getting what seem to be very random IP addresses.  I'm not a networking expert by any means, but I thought a LAN always had the first two digits of an IP address the same.  That is NOT happening for some reason, though it's possible my understanding of LANs and IP addressing is wrong. ... View more

Resolve "Alerting" status

by in Meraki Go
‎Nov 17 2019 7:20 PM
‎Nov 17 2019 7:20 PM
I just installed a full Meraki GO setup in my office this weekend including a Security Gateway, 24 Port Switch and two GR10 AP's.  Unfortunately something just isn't working correctly.  The gateway and one AP are showing Online, but the switch and the other AP are showing "Alerting" status for well over 24 hours.   I've power cycled and disconnected/reconnected everything to no avail.   I have a ticket open with support but haven't heard back and I have an office full of people coming to work in the AM who need connectivity.   Any ideas on a resolution?     ... View more
My Accepted Solutions
View all
© 2025 Cisco Systems, Inc.