Meraki

cmr · ‎Jun 4 2024

@JohanPlukon the change rate is more important than the quantity. As a small part of a role I was managing 140 APs, 50 switches and 25 MXs as there were only a handful of changes each day.

Jamest201 · ‎Dec 15 2023

Yep same here, thanks Meraki for the unnecessary drama on a Friday

TBHPTL · ‎Sep 22 2023

The MX will handle the DHCP just fine if you appropriately size them. I find that Meraki is very conservative with their stated throughput and capacities.

JacekJ · ‎Sep 7 2023

Exactly what I meant above 🙂

PhilipDAth · ‎Jul 31 2023

If the SD-WAN is down - is there anything left for the users to access? You could also consider a backup circuit like cellular.

PhilipDAth · ‎Jun 23 2023

I agree. The threat landscape has evolved, and security systems and practices must evolve as a result.

Brash · ‎Apr 20 2023

Assuming the windows and Linux servers are end hosts and not doing any sort of bridging or switching, you would want BPDU guard (to ensure we don't accept body's from the server). I would also set udld to alert only as it's less likely you'll see a loop on this interface from a unidirectional flow issue. If they're designed to act as software switches, you'd want to look at root guard and potentially udld enforcement.

GIdenJoe · ‎Oct 10 2022

You didn't need the host , only radius communicates on that port. If your AP does not send anything when the client connects to it (so be sure it is a new session, not a roam) then the AP is not doing anything towards the radius servers. Another important note though: Dashboard captures can be a bit finnicky and it is possible your capture stopped capturing packets a long time ago. It is best if you use dashboard captures that you keep to the 30 seconds to 60 seconds mark and immediately try to connect.

JohanPlukon · ‎Sep 16 2022

Im running on the 28.6 firmware

JohanPlukon · ‎Sep 1 2022

Appeared you had to type the string manualy instead of copy pasting it.

Meraki

Community

About JohanPlukon

JohanPlukon

Johan de Lange

Community Record

Badges

Re: How many swichtes, mx and access points per engineer

Re: Packet Fragments detected

Re: Where to run DHCP? MS425 as L3 ? MX450 as L3 ? or MS425 as L3 and relay...

Re: Staged stack updates

Re: Meraki and Cisco ISE

Re: Supplier remote access

Re: UDLD and stp guard and lacp bonds

Re: Specific AP having radius server did not respond issue

Re: U-APSD failures

Re: SAML SSO with adfs

Re: SAML SSO with adfs

Staged stack updates

Re: Staged stack updates