Similar 'problem' here with my QNAP. Nothing new to this topic? ... View more

@ManolisFr  Was hibernation the answer? ... View more

Thanx for the info guys I cannot find the KB patch from microsoft. Do you have any direct link?   But ..Our server is not a DNS server for our network. We run only SQL , also we haven't active directory Maybe this patch isn't necessary for us?   All the "attacks" blocked by meraki and our cpu usage is about 10-20% all the time ... View more

Good morning Blake The ISP'S router is a technicolor DGA4130 which has no clear bridge mode but a configuration which named   Fixed ip mode Our MX64 has a local ip ( 192.168.16.254) and from the beginning i enabled the fixed ip mode with the following configuratin IP 192.168.16.249/24 and 192.168.16.254 as gateway.   In the local MX appliance i added the following on uplink configuration (internet port) Connection Type : PPPoE Use Authentication : Yes username : the username that i  have from the ISP passwords : the password that i have from the ISP IP assignment : Static (I also had dynamic sometimes). The Wan IP we have is static And the wan ip address at the end which we have from the isp   The above configuration worked fine from February to June and the problems started at 12-13 of June   The strange of the whole case is that the other connection which is on Port4 works fine with no problems ( same config) Sometimes when i have lot of failovers i add a tplink cheap modem router which is more stable than the technicolor and i have no disconnections (not at all but sometime for 3-4-5 days i have no failovers from the tplink)   Events from Technicolor are the following when the connection failover   XDSL G.inp Mode Disabled XDSL G.inp Mode Enabled       ... View more

I can connect to my computer over remote desktop (anydesk) , the local network works fine. But the dashboard seems that has a connection problem to the cloud   Edit I called before some minutes the meraki support. They cannot reach my equiment, so i will go tomorrow morning to my work to make a power off/power on physically   Edit again The problem solved right now...Maybe itself..I have access again to cloud dashboard ... View more

Till now (from 05:00am this morning) i had 5 disconnections/reconnections.   So i changed the technicolor modem router with a tp-link we have for backup reasons, and i have no disconnections again.     ... View more

>Lan 4 which working as wan port on meraki is a gigabit port but tp link is 10/100    The two devices should auto-negotiate a compatible speed and duplex.  Where they both reporting as running at 100Mb/s full duplex? ... View more

To add to the answer of @MerakiDave . That sequence of intrusion detection log messages is a known issue that is supposed to be solved in firmware version 14.31 according to this topic: https://community.meraki.com/t5/Security-SD-WAN/Intrusion-Detection-Error-Log/td-p/20568   But as far as I can see the stable releases are still on 13.36.   If it bothers you you can upgrade to the newer firmware from Organization > Firmware Upgrades and then going to the All networks tab. Find your MX, select it, and click the Schedule upgrades button. ... View more