Meraki

guile99 · ‎Oct 8 2023

I've noticed yesterday that my MR52 access pt., that link aggregation is not working. Is there anything need to configure in the Access Point itself? It was working before when i installed it., speed operation should be a total of 2gbps for both 2 x 1000Mbps ethernet port.

Brash · ‎Oct 8 2023

Your Ethernet 1 is showing negotiated to 100Mbps.

You won't be able to have a 1Gbps link and a 1Mbps link in an etherchannel.

Swap out the cables for that connection. Most likely a cable issue.

View solution in original post

alemabrahao · ‎Oct 8 2023

Check the documentation.

https://documentation.meraki.com/MR/Client_Addressing_and_Bridging/MR_Link_Aggregation_Configuration...

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

BlakeRichardson · ‎Oct 8 2023

What type of switch is the MR connected to and is link aggregation enabled at that end?

If you found this post helpful, please give it Kudos. If my answer solves your problem, please click Accept as Solution so others can benefit from it.

alemabrahao · ‎Oct 8 2023

It looks like a catalyst switch. Don't you think?

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

guile99 · ‎Oct 8 2023

cisco catalyst 2960-x

alemabrahao · ‎Oct 8 2023

@guile99 the @Brash is right. It looks like a cable issue.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Brash · ‎Oct 8 2023

Your Ethernet 1 is showing negotiated to 100Mbps.

You won't be able to have a 1Gbps link and a 1Mbps link in an etherchannel.

Swap out the cables for that connection. Most likely a cable issue.

alemabrahao · ‎Oct 8 2023

It makes sense.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

guile99 · ‎Oct 8 2023

thanks a lot, just replaced the lan cable.

DarrenOC · ‎Oct 9 2023

@guile99 , remember your OSI model? Work from the bottom when troubleshooting.

Darren OConnor | doconnor@resalire.co.uk
https://www.linkedin.com/in/darrenoconnor/

I'm not an employee of Cisco/Meraki. My posts are based on Meraki best practice and what has worked for me in the field.

Meraki

Community

Unable to activate link aggregation on both ethernet MR52 AP

Unable to activate link aggregation on both ethernet MR52 AP