Unable to activate link aggregation on both ethernet MR52 AP

Solved
guile99
Here to help

Unable to activate link aggregation on both ethernet MR52 AP

I've noticed yesterday that my MR52 access pt., that link aggregation is not working. Is there anything need to configure in the Access Point itself? It was working before when i installed it., speed operation should be a total of 2gbps for both 2 x 1000Mbps ethernet port.

guile99_0-1696812690153.pngguile99_1-1696812735277.png

 

1 Accepted Solution
Brash
Kind of a big deal
Kind of a big deal

Your Ethernet 1 is showing negotiated to 100Mbps.

You won't be able to have a 1Gbps link and a 1Mbps link in an etherchannel.

Swap out the cables for that connection. Most likely a cable issue.

View solution in original post

9 Replies 9
alemabrahao
Kind of a big deal
Kind of a big deal

Check the documentation.

 

https://documentation.meraki.com/MR/Client_Addressing_and_Bridging/MR_Link_Aggregation_Configuration...

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
BlakeRichardson
Kind of a big deal
Kind of a big deal

What type of switch is the MR connected to and is link aggregation enabled at that end?

If you found this post helpful, please give it Kudos. If my answer solves your problem, please click Accept as Solution so others can benefit from it.
alemabrahao
Kind of a big deal
Kind of a big deal

It looks like a catalyst switch. Don't you think?

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
guile99
Here to help

cisco catalyst 2960-x

 

alemabrahao
Kind of a big deal
Kind of a big deal

@guile99  the @Brash is right. It looks like a cable issue.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
Brash
Kind of a big deal
Kind of a big deal

Your Ethernet 1 is showing negotiated to 100Mbps.

You won't be able to have a 1Gbps link and a 1Mbps link in an etherchannel.

Swap out the cables for that connection. Most likely a cable issue.

alemabrahao
Kind of a big deal
Kind of a big deal

It makes sense.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
guile99
Here to help

thanks a lot, just replaced the lan cable.

guile99_0-1696817874057.png

 

DarrenOC
Kind of a big deal
Kind of a big deal

@guile99 , remember your OSI model? Work from the bottom when troubleshooting.

 

DarrenOC_0-1696835318358.jpeg

 

Darren OConnor | doconnor@resalire.co.uk
https://www.linkedin.com/in/darrenoconnor/

I'm not an employee of Cisco/Meraki. My posts are based on Meraki best practice and what has worked for me in the field.
Get notified when there are additional replies to this discussion.