SSID allowing access to wired clients setting

[RumorConsumer]

I cannot figure out why I cant find this setting...

In the SSID overview there is a setting called

"Wired clients are part of Wi-Fi network"

This SSID is set to bridged mode.

Heres the firewall settings:

What am I missing?

[BrandonS]

Those are wireless (MR) settings you are referring to, not firewall (MX) settings.  What Meraki gear do you have?

[RumorConsumer]

A ton of MRs and a MX65. Those settings exist for each individual SSID.

[RumorConsumer]

I would also like to note for the record that I just made Model Citizen on here. Woo!

[BrandonS]

I see.  I think you are looking for Wireless > Access Control > Client IP assignment then.

[RumorConsumer]

Its wireless/configure/firewall and traffic shaping. Do you know where this setting would be changed?

[BrandonS]

I may be confused.  You are looking for these settings? 

 

[whistleblower]

it's an older topic but for the sake of completeness...
please have a look under --> Network-wide/General/Device configuration

I guess this is the setting you´re looking for!

[IdinkIno]

This is an old chain but I had the same question.  Where is the setting?  Thought about it and wondered, is it possible that your APs are those with network ports on them and you activated a Port Profile or have a device attached to them that joined that SSID?