Thanks for help !
Solved! Go to solution.
If that dhcp discover is at vlan 100 you have to check on the switchport and /or at the dhcp server if you see that discover there also
Firewall rule blocking access to local lan to receive an IP?
Wireless - configure - Firewall & traffic shaping
Tried it in bridge mode?
Hi MarcP,
Thanks for your reply, here is my firewall configuration, normally everything passes.
I have already tried in Bridge Mode but the problem persists 😞
When you configure another port directly into vl100 and connect your notebook to it, do you get an ip?
Just to sort out a problem "behind" Meraki AP.
Is vl100 in your switch uplink to your Coreswitch/Firewall?
Is it working with the cisco classic AP? Connected to the same switch or another?
Start a packet capture on AP lan port.
Connect to the New ssid.
Open the capture
Filter on "bootp" and see if some dhcp traffic is tagged for vlan100. And what is missing
Hi ww !
I have DHCP Discover in the capture but I get no IP.
I configured my port like this:
vlan 69 port default 3/24
vlan 100 802.1q 3/24
If that dhcp discover is at vlan 100 you have to check on the switchport and /or at the dhcp server if you see that discover there also
@CESI Is the DHCP server directly connected to VLAN 100 or is there a DHCP helper entry on the routed interface/default gateway of VLAN 100 pointing at the DHCP server?
Did you already contacted the support as well? This sounds really strange.
Another AP tested? 😄 Maybe yours is faulty 😞 Don´t know something else.
Yes, I think I will contact the support.
I have only one AP 😞 I hope it is functional 😅
It works!
So I tagged my two VLANs and did the same on my SSID's
But the first time it didn't work.
Thanks for help ! 🙂
Can you show the config of your port?
otherwise I have no idea what can cause the problem.
Maybe @ww @cmr or @BlakeRichardson have 😄 😛
Follow this document and check it helps you
https://documentation.meraki.com/MR/Client_Addressing_and_Bridging/VLAN_Tagging_on_MR_Access_Points
Regards
Inderdeep