Switch Management page not loading

[BillMcC]

Anyone else getting an error when attempting to manage switches in the dashboard.

We are all getting "View Failed to Load"

[Eduardo_Cardena]

The same error on Wireless Network...

[PhilipDAth]

I'm having problems, and I have customers reporting problems.

[BarryGould]

I have the same issue "View Failed To Load" , does anyone have any answers ?

[Eduardo_Cardena]

I didnt found some official cisco announcement about this issue

[BillMcC]

At this point I would think it is a back end issue. Just wanted to check with community and make sure it was not just our account that was having issues. Hopefully they are all over it by now.

[VegasLancer]

Same here on two separate meraki accounts I manage. Wireless users aren't re-associating with new APs with out forgetting the network and rejoining near a new AP.

[SPeacock]

Same here.  Meraki wireless management "view failed to load"

[Network-dad]

Same here must be a out of band issue.

[JimTolson]

Same here. Meraki switch and wireless management "view failed to load"

[MattinVegas]

Same in Nevada area for switches and AP. Security Appliance dash is fine . No issues reported by users but very bad timing. 

[pratikvyas]

Meraki is aware of the issue with the page not loading for nodes(MR, MS & MV), this only affects the out of band management of the nodes from the Dashboard. Based on the information available, there should not be any impact on end-user traffic. A fix should be in place shortly, this post would be updated after the fix has been rolled out. 

We appreciate your patience with this. 

[pratikvyas · Accepted solution]

Fix has been applied. It would take some time for the fix to take effect across all organizations within the Meraki Dashboard.

[SPeacock]

I'm back up, thanks!