Verified VLAN 32 does not exist.
Verified subnet does not exist.
Security & SD-WAN > Configure > Addressing & VLANS
Routing
Add VLAN
VLAN name. Corporate
VLAN ID 32
Group policy None
VPN mode. Disabled
MX IP. 172.16.32.1
Subnet. 172.16.32.0/22
Security & SD-WAN > Configure > DHCP
VLAN 32
Run a DHCP server
1 day
Proxy to upstream DNS
Boot options disabled
Solved! Go to solution.
Hi @JED2021 , the Config looks fine as that would create your later 3 interface on the MX which I assume you’ll Trunk to your down stream switches.
Just one question, why not configure the L3 int on your switches instead? Are your switches L2 only or was this done from a security perspective?
Vlan 32 is new and will support layer 3.
It is added via the MX250 not the switches.
VLANs are a layer 2 construct, they become layer 3 enabled by creating an interface either on an MS or MX. Are you asking if your setup is correct? If so then it looks okay to me.
yes I understand the statement.
Its is added on the MX so it is supporting layer 3.
I was just seeking a +1 since more of an IOS person not a Meraki Gui
Hi @JED2021 , the Config looks fine as that would create your later 3 interface on the MX which I assume you’ll Trunk to your down stream switches.
Just one question, why not configure the L3 int on your switches instead? Are your switches L2 only or was this done from a security perspective?