Missing Clients MX64

[StuKoalaIT]

Morning all,

I'm trying to setup a NAT configuration for our Telephone system however the MX64 isn't displaying the client and local IP address. I can connect to the local IP address fine it's just the MX64 isn't picking it up under the client list. I also have the same thing for our Ruckus controller which is odd.

When I scan the network using LAN scan it picks them up fine so I'm a little confused as to why the MX64 won't pick them up.

Thanks in advance,

Stu

[AjitKumar]

Hi 

This is strange.

How about firmware update?

VLANs are on MX?

Also hope the firewall is in Routed Mode not Passthrough Mode.

[StuKoalaIT · Accepted solution]

Just realised those particular clients had a different Router IP, oops.