Is AutoVPN formed between Meraki peers based on IPSEC protocol?

Lohith
Comes here often

Is AutoVPN formed between Meraki peers based on IPSEC protocol?

Is AutoVPN formed between Meraki peers based on IPSEC protocol? And what will be the preferred IKE version(V1/V2).

5 REPLIES 5
Inderdeep
Kind of a big deal
Kind of a big deal

@Lohith : yes it uses IPSEC tunnels, Please read this below link

https://documentation.meraki.com/MX/Site-to-site_VPN/Site-to-Site_VPN_Settings 

Regards/Inder
Cisco IT Blogs awarded in 2020 & 2021
www.thenetworkdna.com
Lohith
Comes here often

@Inderdeep , Thanks for the response. My Meraki MX80 cannot be upgraded to versions above 15. So it will not support IKEv2. So when it participates in AutoVPN will it use IKEv1 to form the tunnels.

Inderdeep
Kind of a big deal
Kind of a big deal

@Lohith :Yes it is using IKEv1. 

Inderdeep_0-1632835245295.png

 

Regards/Inder
Cisco IT Blogs awarded in 2020 & 2021
www.thenetworkdna.com
Lohith
Comes here often

@Inderdeep : In the document it was referring to Non-Meraki peers. Could not find any document for Meraki Peers. Any possible way to check in logs to know the IKE version to confirm.

rhbirkelund
Kind of a big deal

You can take a look at this White Paper from 2020, regarding AutoVPN formation.

LinkedIn ::: https://blog.rhbirkelund.dk/

Like what you see? - Give a Kudo ## Did it answer your question? - Mark it as a Solution 🙂

All code examples are provided as is. Responsibility for Code execution lies solely your own.
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels