WPA3 is there since a few times but no support for WPA3 and 802.1x with Meraki Cloud Authentication ! Is there any plan to support it ? Thanks in advance. Nicolas ... View more

No I am not also tagging the SSID with 999.  I have 3 other SSIDs that are tagged as VLAN 10, 20, 30.  They all work fine, but the Tesla will not connect to them.  I created A new SSID and I choose to not VLAN tag it.  Now the Tesla connects.  But by not tagging it, it traverses the native VLAN.   ... View more

Same here, but I get a message at the top saying they are making changes.     ... View more

About 1/3 of my clients are AX — iPhones, 2020 iPad Pros, and Intel Ax200/201s.  ... View more

Philip,   Ok for this scenario.   How could I have seamless roaming with no cut on existing sessions with the following ?  - internet access is done using MG21, could have multiple MG21 for bandwidth and high avaiblity  - one single SSID compose with MRs linked using MS120 and others using Wireless Mesh   But I suppose in this case the Wireless Mesh network cannot itself use multiple MG21 only one will be valid ? The other way as you explain is to use MX to load balance link ? Correct ?   ... View more

@pjc26.x will continue to get security and functional fixes, just not new major features.  Hence the support up to 26.99 when we are only on 26.8.1 at the moment.  I think that if you configure a network that has a mix of devices with 27.x then the newer devices will get 27.x and the older ones will get the latest 26.x.  Obviously you cannot use new functional features that rely on 27.x.   We have been doing a bit of rationalising and have been replacing the 802.11ac Wave 1 APs at sites with only a few with Wave 2 APs from sites where most are Wave 1, thereby allowing us to use the new features in the now all Wave 2 sites if required. ... View more

This solution worked, thanks everyone! ... View more

I found the connected switchport to also be a good indicator of traffic. You'd of course need to only have the source connected to said switchport to reliably see the in and output. ... View more

Thanks for the feedback @Brambo I think this just confirms the MR45 and MR55 are still having a continuation of issues since their conception. ... View more

Hi Wickus,   Not yet tried. I will do some test, thanks. Seems to be easy and simple. ... View more

Help!   The AP - MR52 - that I have tagged for my special hidden Sonos-only SSID was a repeater and has since been wired to a port on my MX65 to become a gateway. Yay. But now all my Sonos devices connect to the right SSID and same AP, but pull 169 addresses for some reason. No other changes were made. Right? Wrong? Thoughts? Restart MX?   I have also tried removing the Sonos tag from the AP tags section on its status page as well as deleting and re-adding the VLAN. When I join the hidden network with my Mac I am able to join but my Mac also pulls a 169 IP so its not just the Sonos.   FIXED - I have a netgear switch in the middle and I didnt configure its VLAN settings. Got it. ... View more

Ok. I will contact my ISP for changing their router config to bridge mode.     ... View more

Hmm... interesting. Unfortunately we don't utilize any AD features in our setup, just reset the iPads every few months and re-enrol via using the downloaded Meraki profile in AC2. ... View more

Excellent ! ... View more