Hi there,   I recently discovered that a small number of our WAPs that should be connected to the switches at 1000 Mbps are showing as 100 Mbps in Meraki console. I've looked through the available alerts and can only find ones that alert if the gateway goes offline or becomes a repeater. Does anyone know of a way of setting up alerts so I'm notified next time this happens?   Thanks! ... View more

Hi All,   I have recently inherited the job of managing our Meraki infrastructure, which was installed two years ago by an external company and consists of Cisco Meraki core switches and fibre switches, MS225 network switches and RM36 / MR46 WAPs.   I'd like to update the firmware on our MS225 switches, but all our devices are currently tied to one of two site-specific templates. Therefore, I cannot target a small number of switches to validate the new firmware on.   After doing a bit of research, it looks like I have three options:   1) Deploy the firmware across all the devices and hope there aren't any issues, relying on automated or manual roll-back if serious issues arise. 2) Take the devices out of the Templates and put them into Groups for a Staged Upgrade approach. 3) Create additional Templates so I can have one for testing and one for the majority of our devices.   But I'm not sure what's the best thing to do. We don't have a full support contract for our network at the moment, only a bank of support hours that are quite expensive and I hope to avoid dipping into.   Any advice would be welcome 🙂   Tim     ... View more