Hello all!  Have a scenario I need some advice on.  We will be creating two switch stacks of Meraki MS250's in a new building.  Stack A will have a connection back to our core switch 1 and Stack B will have a connection back to core switch 2.  Is it possible to connect the two stacks to each other just in case we would lose fiber connection back to one of the core switches without creating a loop?  Trying to figure out how to keep one of the stacks connected if we would lose a connection back to one of the cores. ... View more

Hello all,   I have a Cisco Catalyst 9300 that was migrated to Meraki that is not working. It is in the dashboard but I cannot connect to it no matter how I connect it to the network.  I really need to factory reset it but this dang BOOT_DEVICE_MODE is set to meraki will not let me bypass it to get into the cli to do anything.  Is there a way to bypass this?  I have held down the mode button on boot, pressed it three times once the switch LED begins flashing, etc.. but I cannot get past it.  Any suggestions welcome as I have an unusable switch at this point. ... View more