Meraki

iagoaas · ‎Jun 23 2023

this is my configuration on port from MS to MX.

iagoaas · ‎Jun 23 2023

NO! this is my configuration on port from MS to MX.

iagoaas · ‎Jun 23 2023

Your switches are 1 stack? (I asume stack port 1 goes to 2) I have 2 stacs - SW01 port 1 goes SW2 port 2 and SW2 goes port1 sw1. Do you have the same native vlan on all ports in that drawing? YES

iagoaas · ‎Jun 23 2023

Guys, can you help me, today I have this connection between the 2 MX and 2 MS with two links and a stack, but I am receiving many STP BPDU errors on ports 17 and 18 of the MS, which has caused instabilities in the network. Can you tell me if this connection is recommended between the MX and the MS? Today I have two links one for each MX but the stack. To resolve network instability as a palliative today, the MS 02 is turned off, so I don't have a BPDU error on the network, but if he turns on the SW 02, the problem occurs again.

iagoaas · ‎May 8 2023

OK, got it, thanks for the feedback. Actually my internet provider is giving me a /31 network. with that I'm trying to put an MS120 before two MX to get a balance.

iagoaas · ‎May 8 2023

Switch MS120 does not support configuring a port with network /31? I am trying to configure an MS120 port with a mask of 254, but I get the message below. ERROR: Static IP should not equal broacast, gateway must be valid IP address.

iagoaas · ‎May 8 2023

I just verified that my (INTERNET) circuit delivers /31 and the meraki MS120 switch does not support it.

iagoaas · ‎Apr 24 2023

excellent, i am try this, thank very much.😊

iagoaas · ‎Apr 24 2023

hi guys, Is it possible for me to connect my internet link first to a switch (MS), and then exit with two cables, one for each MX? I have only one internet link (just 1 IP) but I have two MX's at the other end.

Meraki

Community

About iagoaas

iagoaas

Community Record

Badges

Re: Erro STP BPDU sender conflit

Re: Erro STP BPDU sender conflit

Re: Erro STP BPDU sender conflit

Erro STP BPDU sender conflit

Re: Switch MS120 does not support configuring a port with network /31?

Switch MS120 does not support configuring a port with network /31?

Re: Is it possible for me to connect my internet link first to a switch (MS...

Re: Is it possible for me to connect my internet link first to a switch (MS...

Is it possible for me to connect my internet link first to a switch (MS)