Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About jphamwd

Re: AnyConnect - Automatic VPN Policy

by in Security & SD-WAN
‎Jul 31 2023 5:01 PM
‎Jul 31 2023 5:01 PM
Misunderstood the functionality of this feature. I was under the impression if i was onsite and tried to connect it would not allow or auto-disconnect me, but TAC clarified that the purpose of the setting is to disconnect you if you initiate an AnyConnect session in an untrusted network and move to a trusted. Ex - put your laptop to sleep while on AnyConnect at home and connect to your enterprise wifi with AnyConnect still running when your laptop wakes up ... View more

AnyConnect - Automatic VPN Policy

by in Security & SD-WAN
‎Jul 31 2023 4:19 PM
‎Jul 31 2023 4:19 PM
We have users that are connecting to AnyConnect whilst onsite, I am attempting to enable the Automatic VPN policy, with "Trusted Network Policy" set to "Disconnect"   The AnyConnect client states "On a trusted network" before I connect, but allows me to connect anyway and never auto disconnects. According to the MX vs ASA spec sheet, it supports TND (trusted network detection) via the profile   I have a ticket open with Cisco TAC and they had me run a dart diagnostic and send it over, but wanted to see if anybody here has successfully implemented this feature ... View more

Re: MX400 configured with VRRP (warm-spare) Software Panic on MX16 and MX17

by in Security & SD-WAN
‎Mar 28 2023 10:47 AM
‎Mar 28 2023 10:47 AM
For the MX400|600 support confirmed the VRRP software panic will be a known issue until model end of life as they will not get any firmware above 16 ... View more

Re: MX400 configured with VRRP (warm-spare) Software Panic on MX16 and MX17

by in Security & SD-WAN
‎Feb 21 2023 9:34 AM
‎Feb 21 2023 9:34 AM
My support case is still open, no update since this response back in July:   "The Primary MX rebooted due to an issue that engineering is investigating. I've attached this case to our internal tracking for the issue. It affects firmware 16 and 17. Once there is an update I can report back." ... View more

Re: MX400 configured with VRRP (warm-spare) Software Panic on MX16 and MX17

by in Security & SD-WAN
‎Jul 25 2022 10:02 AM
‎Jul 25 2022 10:02 AM
I just subbed a ticket on this, out of nowhere we lost VRRP hearbeats and failed over to the standby.  There is a note in the firmware that the MX400s use 16.16.3 code if you take it up to 17, sounds like there will be another 16 patch.   ... View more

Re: AWS Direct Connect + Meraki BGP

by in Security & SD-WAN
‎Apr 4 2022 8:49 AM
‎Apr 4 2022 8:49 AM
Were you able to get AWS DX implemented?  If so, what does your topology look like and what has your experience with it been like so far? ... View more
My Accepted Solutions
View all
© 2024 Cisco Systems, Inc.