cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
  • About JFridolf-Iver

Re: MX75 HA question

by in Security / SD-WAN
a week ago
a week ago
P2 on the MX is the "Internet 2" port (port 2) These ports are then connected to each of the Switches FW01-P2 > SW01-P3 FW02-P2 > SW02-P5 which is set to the same VLAN as the port containing the ISP (SW01-P1).   P4 and P5 on the MX are the "LAN ports", which are set to trunk as per usual.    So they go to each of the Core-switches FW1-P4 > SW01-P7 FW1-P5 > SW02-P8   FW2-P4 > SW01-P9 FW2-P5 > SW02-P10   (STP to protect the network from loops) ... View more

MX75 HA question

by in Security / SD-WAN
a week ago
a week ago
I was told recently that it should be no issue that have two MX75 in a HA (passive/ready) configuration with only 1 external IP address.    So I bought two MX75 and started configuring them.    As soon as I add the spare and set it to "MX IP", I rather immediately get a issue where it states that there is a duplicate IP configured and then the two firewalls takes turn on being primary/spare.    Is it so that this can't be done and I have to do it "old style" where each of the MX has there own external IP?   Are there any other options?    For reference I have connected it all as per following drawing:    ... View more

Re: Add MX appliance to existing live network

by in Security / SD-WAN
‎01-03-2023 11:56 PM
‎01-03-2023 11:56 PM
I'm at the stage of adding the MX to the dashboard, and that's where I got worried So perfect, thanks for your answer, exactly what I wanted to know 🙂 ... View more

Add MX appliance to existing live network

by in Security / SD-WAN
‎01-03-2023 11:28 PM
‎01-03-2023 11:28 PM
I have an existing network that is running with MPLS and no MX appliance, however there are MS and MR appliances.  The network is not configured with any VLANs or equal via the MS appliances.    My current mission is to remove the MPLS and add local Internet breakout via the MX appliance.  I will also begin segmenting the network to secure it more/better, which will be done in orderly forms and gradually.    However, when I add the MX appliance to the network and the Security part becomes active, will this have impact on the current network?  i.e. will the network re-configure anything current and potentially "go up and down" ?    As stated the current setup is not configured for any VLANs or equal, everything is running on one VLAN (default) and all ports are configured as trunk that allow all (not by me!)   Thanks in advance.  ... View more
© 2023 Meraki