Check under Network-Wide/Users (just a guess). ... View more

Glad you got it working. 😄 ... View more

I've had case where it seems not to pick up the config file (in the new location). This is for when the AnyConnect Client was previously installed. ... View more

Tests on local LAN and S2S VPN. Client VPN is necessary to reconnect as mentioned by @PhilipDAth . ... View more

I just asked the case owner about that. See if I can get to 16.x all around.   Advanced Security. IPS/IDS is on....but this is over site-to-site. Internet speed is not an issue at all. Get full circuit speed when doing a test from any of the locations.  ... View more

I did a little poking around and it turns out that it is only listening on port 81 to VLANS that have VPN Mode Enabled. Any MX IP addresses that are for VLANS with VPN Mode Disabled are not open on port 81. ... View more

Were you able to find a solution to this?   ... View more

I think you are refering to the DDNS adress ? ( since you left a comment on a different post regarding DDNS ).   If so , you need to use the endpoint :  {0}/devices/{1}/managementInterface ... View more

No.   Note that if you do use another device for bonjour forwarding it doesn't usually work if the printers are on the native VLAN (usually 1).  You normally have to create a separate dedicated VLAN. ... View more

>The Duo application setup requires the Meraki Consumer URL to be configured for the application.    This is not a Duo "thing" but a Meraki "thing".  It is the same for all Idps.   It is not correct that it only gives access to one org.  It gives access to all orgs via the MSP portal for which SAML authentication has been configured.   Check out this section on configuring the Idp for MSPs. https://documentation.meraki.com/General_Administration/Managing_Dashboard_Access/Configuring_SAML_Single_Sign-on_for_Dashboard#SAML_SSO_for_MSPs  ... View more

@almightythor totally agree about the VPN, it is a shambles.  Also the SD-WAN has issues where if you have full tunnel from a z3 to an advanced license MX and then out, the advanced features such as L7 don't get applied to traffic from the z3.   However MX15 is reliable,  we've been using it for over a year across our 24/7 enterprise and are happy with the reliability.   FYI we use Sophos for our L7 firewalling and client VPN, so the issues you have and we would have with a full Meraki stack, don't appear. ... View more

The Metro-E is carrying voice, and the internet connection stinks.....so I'll set up rules accordingly.   I just wanted to make sure the MX will do what I was thinking it would do on the Metro-E side. If that can route VoIP and other traffic between the sites, that will be great. ... View more

Correct, there is no update. ... View more

How about that?!? I remember trying to do that some time ago and those columns were not in there. Glad they are there now! ... View more