Hi together, we have a bad condition with MR 29.6.1 → MR 30.5 on  AP MR36 .... Let's try to describe: We have 100 AP's, MR33, 36, 55 ... In some classrooms we didn't have enough RJ-45 plug near the beamer/projector, so we had used network Splitter. (1) This had works well with Firmware up to 29.6.1. After Upgrade to Firmware MR 30.5 all MR36 no longer has network connection to the MS Switches, if they are connected through a Network Splitter. They still are powered with PoE and could mesh, but they no longer accept the LAN Cable. On the Meraki Networkswitch the Accesspoint Port ist showen as only PoE, but not LAN connected MR33 don't have this issue with MR 30.5 MR36 don't have this issue without splitter, or with the Firmware MR 29.6.x (or MR 28.x) If i replace a "failed MR36" with a MR33, it work on the same cable with the Firmware 30.5. I downgrade for now the firmware back to 29.6.1 and it's all "fine" - but we would like to use the a newer Firmware MR 30.x if the "bug" is fixed. ... Yes, RJ-45 Splitters aren't the greatest way to use a single Cat6e Port as two Cat 5e Ports. Sadly we can't use a tiny network switch as we had two completly different VLAN Settings on this Cat5e Ports. 1)  PS: probely i'll have to open a bug report ... View more

Hello, we are a school with about 80 Rooms and in every room is a wireless connection to the laser beamer. This connector is called "AirTame". Is there a easy way to switch off client balancing for only a specific device group? Since we switched to MR 29.x we see that the Airtame device on the room connects many times per hour to an other room. As Airtames are physicaly located we know they don't move, it's clear a problem of the client balancing. We see in the logfiles that client balancing redirect the connected airtame out of the room. As the airtames are time critical it's not a good idea to redicrect an AirTame from Room A to Room B.  As we are in a School evoriment, it would be often that one room is free and an other full. We understand why client balancing think Room B looks as a better choice. But as the signal in an other room is worse, it isn't 🙂   Is there a easy way to switch off client balancing for only a specific device group? None of this entry try to move it back to the correct room, where it's located. With switched OFF client balancing in this building, the airtame keeps in the correct room, but the other clients (aka student notebooks) would also no longer distributed. The client balancing has this problem only in a single building [~20 Rooms], in the other the airtames keeped i the room where they are located 🙂   We allready have minimum bitrate at 24mbps, limited Radiotransmit power 5 - 16dBm [5GHz] / 4 - 10 dBm [2.4GHz] ... View more