I am setting 10 Dell PowerEdge Server to my Meraki MS 425 Switch.  The Dell server use to ports (DHCP, iDRAC).  One of the ports will get a DHCP Address from the switch.  However, the other port will need a static address to allow our system admin to access iDRAC.   Is it possible to have a static port with an address and how would I set it up?  Just food for thought, I will need to setup 10 static address for 10 dell servers.   Thanks in advance for the information.   ~ Jerry ... View more

I am replacing our Core Switches (Cisco Catalyst 9200L) with Meraki MS-425's.   Can I utilize the configs from the C9200L on the Meraki MS-425's.  Is there any process that you can provide that will make the conversion process easier?   We are doing the swap on this Saturday.   Thanks for any information or suggestions you can provide.   Regards,   ~ Jerry ... View more

We have approximately 15 AP's (MR-52) in our building.  During the past week I have seen a trend in client devices not connecting to AP's that are close in proximity.  It appears that devices will connect to AP at a farther distance than the AP that is closes to it.  In other words, some users devices (phones, pads and laptops are not connecting to the nearest AP.   Also when toggling between SSID's example:  Tarana-Guest and Tarana-SC the radio settings (channel utilization) will show 5 Ghz with clients are connecting to Guest SSID and 2.4 Ghz when clients are connecting to SC SSID.   Does Meraki AP's perform load balancing based of clients devices on a single AP?  Also, what policies are set for devices to switch channels (from 2.4 Ghz to 5 Ghz)?  Are there any settings that I apply?   Thanks for any information you can provide.   Regards,   ~ Jerry ... View more