It Works! It was in the config of the Fortigate. Needed to build an extra phase 2 tunnel instead of putting 2 subnets in one phase 2 configuration.
... View more
Hi, We would like to setup an IPSec tunnel between an MX84 pair and a fortigate 70D. The Fortigate is behind a NAT device which allows IPSec. Error message at the Fortigate is: Negotiation failure. At the Meraki side: phase1 negotiation failed due to send error. 8fc23f30749477ae:0000000000000000 Config on the Meraki side is default with very simple PSK. Anybody got any tips on IPSec settings between Meraki and Fortigate? We've tried several different combinations of sets. Thanks in advance. Ferdy
... View more
If you PUT the following with Postman: { "wan1": { "staticDns": [ "208.67.222.222", "208.67.220.220" ] } } Only the DNS changes from the previous values to (in this case) the Cisco Umbrella (OpenDNS) values. It leaves the other "wan1" values as they were, so thanks a lot for pointing me to the right solution! When using collections together with a CSV in Postman, you can change all AP's at once!
... View more
Just did the first test and the AP comes back with the following: { "wan1": { "usingStaticIp": true, "staticIp": "192.168.1.3", "staticSubnetMask": "255.255.255.0", "staticGatewayIp": "192.168.1.1", "staticDns": [ "8.8.8.8", "8.8.4.4" ], "vlan": null } } Looks promising!
... View more
Hi, I configured around 180 AP's in 1 organization with static IP addresses and static DNS. I would like to change only the DNS settings for all AP's, using API (with Postman app). I cannot change to DHCP because of monitoring systems. Anybody got any suggestions? Thanks!
... View more
Reset the switch to factory default: https://documentation.meraki.com/zGeneral_Administration/Support/Resetting_Cisco_Meraki_Devices_to_Factory_Defaults Connect one of the switchports to the internet modem/router that can provide a DHCP address to the switch. Be sure that the switch can reach the cloud: https://documentation.meraki.com/zGeneral_Administration/Other_Topics/Firewall_Rules_for_Cloud_Connectivity In most cases that would not be an issue.
... View more
If the switch is "out of the box", connect on of the switchports to the internet. For example an internet router/modem that can provide the switch with an IP address. This is the only way the switch can connect to the Meraki dashboard. Connect to the dashboard and configure the switch from there. https://documentation.meraki.com/MS/MS_Overview_and_Specifications/MS120_Overview_and_Specifications states the following: Common Troubleshooting My device is connected to the network but not checking in to the Meraki cloud or shows a solid Orange LED. Confirm that the device is powered on and has a valid IP address that is able to access the Internet. Use the Local Status Page to get more information about the connectivity status of the device such as if it can successfully reach the Local Gateway, Internet, and/or Meraki Cloud servers. If necessary, contact Meraki Support for additional assistance.
... View more
