Meraki

Community

About TimM1

Re: Cannot send data to remote VPN (Site to site)

by in Security & SD-WAN
‎Apr 16 2018 7:48 AM
3 Kudos
‎Apr 16 2018 7:48 AM
3 Kudos
Thanks for the replies.   Issue now solved.   Turned out to be routing on the other side, due to reasons of how the customer does this we basically were not getting responses from the target machine. But they have checked/amended the routing and now we get replies.   Turns out the Meraki VPN setup was fine all along 😉 ... View more

Re: Cannot send data to remote VPN (Site to site)

by in Security & SD-WAN
‎Apr 16 2018 6:34 AM
‎Apr 16 2018 6:34 AM
Hi,   Yes I have private subnets for each remote machine defined in the manager. There are 2 - 3 on each VPN, defined as x.x.x.x/32 and comma separated.   I'll see what can be captured at the far end, the config was supplied to me so I would *hope* it is correct at that end! ... View more

Cannot send data to remote VPN (Site to site)

by in Security & SD-WAN
‎Apr 16 2018 6:01 AM
‎Apr 16 2018 6:01 AM
Hi All,   Would appreciate some assistance as this is the first leap into site to site VPN.   We have an MX64, the remote site (customer) has an ASA Cisco VPN, these are added as non-meraki peers, in VPN status the green light is on for both VPN connections.   Now if I try to contact an IP in the VPN sub net, I cannot get a response. If I tracert then it seems the request goes to the MX64 (as gateway) and dies there. If I try to tracert to the remote VPN router then it seems to trace OK.   We have Windows AD / DHCP / DNS if that makes any difference...   ... View more
© 2024 Cisco Systems, Inc.