Hello,   I was hoping to get some help with setting up a vMX device.  I installed it just fine, but cannot seem to get anything to show as UP in my route table.  There is zero documentation, that I could fine at least, and my SE didn't really shed any light on the subject, pointing me to the "how to install a vMX in AWS" doc.  I need something a lot more in-depth.     FYI - this is setup in Routed mode - already had support help with that.   now for LAN config.  when I first opened the page, it had a random network in there, but that is not the network of AWS.  Do I change that or leave it?  I assumed for MX IP, I use the one that is assigned to the AWS NEI.  when I create a static route, do I use the MX IP as the Gateway, next hop or do I use the AWS standard of ##.##.##.1?   I've double checked my AWS routing and SG's to make sure all is open and available.   really frustrated with the lack of documentation with Meraki products.  PAN you get 100 pages of detailed configuration, Meraki - here is like 5.  good luck.  LOL   thanks for any help!! ... View more

Hello, I work for a startup that decided before I started to go 100% full Meraki.  We have a network stack that comprises of MX68's for small locations and MX250's for large ones.  MS120-8, 250's and 350 switches, and MR64 WAPs.  I am currently in the process of getting SD-WAN working with vMX's running in AWS.   Finding it a bit hard to find documentation on things, so I will be posting on here often to get some help.  I'm used to using PAN and Cisco Nexus gear.   I've been in IT for around 25 years and look forward to working with you all and helping where I can. Shawn ... View more